Thanks Doug

Cummins goofed when they went full electronic on the 855.. Got a Versatile with the old "big cam" mechanical, fires up funs good.. got a truck with the computer.. POS freaking boat anchor!!! BTW, Freightliner air ride or Pete air leaf.. set up right, will out perform walking beams in the field 😁😎👍

Yea 800bu a load was a lot less running around than 300 bu and wait on the trunk to get back!

We're you missing it...lol

JC is a good friend, he would give you the shirt off his back!

Yea this one is split at the seem, looks like it was sodered once before its gonna get fixed this winter! Thanks for watching

That's right!👍

I'm not looking forward to this one just got the clutch yesterday and snow is on the way!

@@cesmith4566 nice. NOT

Never fails always something needs fixing! Thanks Pete

@@cesmith4566 how can I get in touch with you. I have a Toyota skid steer #7 with a bad hydraulic pump. I will sell the loader if I can get the pump fixed

@@stevensaxon8888 cesmith2437@gmail.com

It runs pretty constant at 2500rpm. Doesn't seem to slow down evan in heavy corn. Does anyone still make a concave or rasp bars for a M2? I'm leaving kernels on a few cob's.

@@cesmith4566 Not sure if AGCO still does but if your bars aren't too bad they can be rebuilt. I think Sunnybrook does them and they might offer a new concave too. It's easier to get new L series parts lately.

@@cesmith4566 Did you find new bars and concave yet? Not sure if AGCO offers one still or if they do that it might be much higher priced. Ebay shows a 9 bar which is mainly used for small grain www.ebay.com/itm/V18039-Concave-9-Bar-Fits-Gleaner-Combine-M-MH2-MH3-M2-M3/271416969249?hash=item3f31b64821:g:sdwAAOSwn1FZtgtR I also found a 7 bar that is more for corn/soybeans here www.agriseek.com/s/Gleaner-Concave All State Ag Parts looks like they sell a quality concave but you'd have to call them to get details. www.tractorpartsasap.com/conventional-concave-new-gleaner-103067.html Abilene shows bars with hardware for $950 but they look like the narrow tooth which are needed for small grain. They'll work in corn but in green stem soybeans not so good compared to wide spaced bars. Wide spaced bars do damade wet corn a bit but I rarely combine wet corn with my L2 or R52. By wet, I mean over 22%. I'd be less concerned about 7 vs 9 bar concave and focus on getting wide spaced cylinder bars. Call these suppliers because they may not show that they have the concave or bars but they may still be able to build them. Also call and your AGCO dealer. I have found generally AGCO has better quality and if the box of parts shows up damaged or missing pieces, the other companies might leave you in a bind trying to resolve the issue. I ordered an SCH cut system from AGCO and about 1/3 of the guards were gone because the boxes of parts looked like they traveled through the Battle of the Bulge and my dealer replaced every thing with what he had on hand plus they ordered the wrong knife head and they resolved that right away. It cost my $75 more through AGCO than Shoup.

@@cesmith4566 Also I'd go back to your injection pump and set your high rpm at 2500 to 2550 so you don't have to adjust the speed with the throttle lever. The whole combine will do a better job because the governor will go to it's hard set spot and only dip under load and not overshoot when the load suddenly lightens. Use an rpm gun from NAPA using reflective tape to get true engine rpm when setting it but your monitor will probably be close enough.