Replacing all the factory hard brake lines with new ones from inline tube. I may end up not using the Wilwood master cylinder due to the push rod length not working with the stock booster pushrod.
Пікірлер: 21
@cashcountystreetcars7 ай бұрын
They told me I needed a master with a 1 inch bore a stock ac delco is 9. Something anyway I bought a wilwood never installed it My 45.00 ac delco works great . Glad your on the right track. for me I got a new booster and it solved my issue.💪
@houstontaylor97997 ай бұрын
I think I commented on your IG about the pushrod, had the same issue when I went to a wilwood master cylinder. If you have a machine shop near by you can get the pushrod turned down I just ground mines.
@PENNYLS17 ай бұрын
I’m definitely going to have to do that. I gotta be able to use the Wilwood one
@derekderekison32417 ай бұрын
Good job brother! Keep it up until you figure it out. I dont think ive ever had a project where i didnt get stuck at some point 😅
@dennisalstonZ067 ай бұрын
Did my whole brake system on my 71 Grand Prix I got everything from them.
@mexicanlee7 ай бұрын
Nice update homie and good idea to change the proportioning valve 👍
@krysfijal63847 ай бұрын
The proportion valve sensor needs to come out there’s a tool you screw in it’s place to let you bleed threw it the switch shuts the flow off
@PENNYLS17 ай бұрын
Yeah I have it. Thanks for the heads up.
@JF-sv7qo6 ай бұрын
Thank you for the update
@87SSBOI7 ай бұрын
Thanks for the update bro!!!
@WarrenGBody7 ай бұрын
Nice update fam!!! 💪🏾💪🏾
@TinnonFamilyFarm20 күн бұрын
Did u ever show the ebrake setup? Dont leave us hanging brother you doing great
@PENNYLS120 күн бұрын
Not yet. I’m working on painting the car right now.
@TinnonFamilyFarm20 күн бұрын
@@PENNYLS1 get a wire Swage my brother easy as pie🥧
@PENNYLS120 күн бұрын
@@TinnonFamilyFarm yeah I have that. I showed it in another video. Just haven’t put the system together yet.
@MrOlds84887 ай бұрын
Good shit
@willierebuildz91827 ай бұрын
Have you tried bleeding the brakes the ol school way
@PENNYLS17 ай бұрын
No but I will have to with the stock master cylinder.
@willierebuildz91827 ай бұрын
@@PENNYLS1 I would try that before replacing all the lines your brakes were working before so the lines are probably good
@PENNYLS17 ай бұрын
@@willierebuildz9182 I had the cut the long line to get the soft axel drop line off. It was rusted solid.