Vespa ET4 Piaggio 125 Gearbox & Clutch

Рет қаралды 2,447

Жыл бұрын

Here I show how to remove Vespa ET4 Clutch and gearbox for service and refill with oil. Step by step process
#piaggio
#vespa
#gearbox

Пікірлер: 12

@spyder2001 8 ай бұрын

Hi, should there be any play on the clutch shaft? the reason i have taken mine apart - its a Leader though - is because there was back and forth movement on the clutch shaft. wheh it is pulled 'out' everything is smooth, when its pushed in the clutch gear is rubbing against the gear behind it? neither of the gears look worn and it doesnt look like anything is missing, broken or out of place.

@youcandoit1828 8 ай бұрын

Hi Can you send a picture. If you are talk about the rear part of the drive belt set up there is always a bit of play as the gears mesh. Not a lot thou. Hope this helps. You can do it 👍

@spyder2001 8 ай бұрын

@youcandoit1828 thanks. I found a forum post that describes the same thing and apparently the gear can move on the shaft as it is shrunk on at the factory. I need to work out a way to press the gear in a bit more!

@adilsokolovic12 2 ай бұрын

I've just did the Variator service on my LX and i also have the same thing. In and out movement of the shaft, as well as gears grinding sound when I push the shaft in. I guess it's supposed to be like this.

@spyder2001 2 ай бұрын

@@adilsokolovic12 thanks. I appreciate the information!

@Davidcars1 Ай бұрын

Mine doing the exact same thing although it’s a 2003 can’t seem to get past this iusse at all any help would be appreciated

@proegde161 10 ай бұрын

No video how to change the gearbox oil for Vespa 125 CC ET4 from 96-99,i have one from 97 and cant find a video how to change oil without take of the engine?

@youcandoit1828 10 ай бұрын

Remove the exhaust and then undo the centre nut and remove the rear wheel. Then you can locate the drain bolt and fill bolt in front of you. I,ll post a video in the next weeks. You can do it.

@proegde161 10 ай бұрын

So if i must change the oil in gearbox,must must i then take of the whole engine??

@youcandoit1828 10 ай бұрын

No not al all. Just locate the lower bolt and drain the oil out and refill in the upper bolt hole. You can do it. :)

@proegde161 10 ай бұрын

@@youcandoit1828 I try,i lift it up,i have been look for the screw for gearbox but cant find it,i can imagine that the screw is on the right side somewhere next to flywheel or under it..i have been look everywhere..and no video at KZfaq just for this typical model…

@youcandoit1828 10 ай бұрын

@@proegde161 check the reply to the other message you sent it has instructions. You can do it👍