Another great video. You and the Heating Geek best on KZfaq. Thanks for taking the time to make your videos.
@karpilin4 жыл бұрын
Thanks! Just followed your instructions (minus gas pipe) and managed to replace a leaking flow manifold on my Worcester Greenstar 24i Junior.
@hamzaparvais39482 жыл бұрын
Brilliant video thank u again for knowledgeable info
@d.r.plumbingheating32985 жыл бұрын
Loving your work! WD40 tip is what I have just learnt!
@jitenkothari50732 жыл бұрын
Great video
@BREN20093 жыл бұрын
My boiler was dripping through the ceiling tonight I managed to work out how to get the cover off and then found the manifold part I will get it tomorrow and fit it myself minus touching the gas pipe I tried some expoxy putty from bnq for leaks to put me on but did it hell work i roughened the plastic with sandpaper so it would key to it and left it for 2 hours it was rock hard it and the manifold was dry still leaked water always finds it's way out thanks for your video I will give the clips a spray of wd40 cheers
@charlie123585 жыл бұрын
Once you've done this once its actually not a bad job and overly common, I find the hardest part is getting the old fibre washers off theyre always soaked and caked on then break off in tiny pieces for some reason.
@mhpservices15 жыл бұрын
Massive thanks to Geoffrey for his efforts !!
@24-7ttplumbingheating4 Жыл бұрын
Good video and not to long some videos are just to long .
@justsendmelocation50684 жыл бұрын
Although Worcester are notorious for leaking o rings to pin hole leak manifolds Working on these boilers is straightf forward.
@paulhughes87242 жыл бұрын
Wise move wearing gloves on a Worcester
@antonybuckley26455 жыл бұрын
Great videos, what's the rtn manifold like to do on a Jr
@dzmalekvali11105 жыл бұрын
Mr Jeffery, I'm having my green star junior 24i giving very hot water ,tried boiler dial low setting still very hot,,could it be the hot water sonsor failing at high setting ? I need to go back check it again..ordered new h w sonsor on the way. Thanks
@worboyes1 Жыл бұрын
Had one of these today and the whit clip at the top had part of the old manifold cracked inside it. Such a miserable job on my least favourite boiler!!
@dzmalekvali11105 жыл бұрын
Which bosh boiler?
@_drs43 жыл бұрын
1:20 how did you get that off?
@snigie5 жыл бұрын
Nice easy job once you’ve done a couple, don’t know why people complain about them, they pay my bills 👍🏻 Bypass is the fiddlist bit, wd40 is a nice tip though👍🏻