DIRT CINEMA

Пікірлер

@derjan10 6 күн бұрын

I might be dumb but how do you Keep it cool

@kylemilford5968 Ай бұрын

Curious why you didn't just swap the output shaft cdom.the 4wd in as it's already shorter?

@cade2367 8 күн бұрын

Probably doesn't know how to tear apart a transmission

@melvinrawlings1457 Ай бұрын

New sub here and just have to say very impressive. Much love to yall from Maryland❤❤❤

@Torquemonster440 Ай бұрын

Those headers are sick. 🤘

@MarkCarr331 Ай бұрын

What headers are those? I want same ones, theyre perfect 👌

@marcosbarraza4738 2 ай бұрын

What’s transmission are you running

@raymondquesada6896 3 ай бұрын

What oil pan did you use??

@jorgebribiescas4315 3 ай бұрын

Hola funciona también en una transmisión estándar del 2002 se puede convertir a 4x4

@scottmccoy5688 3 ай бұрын

Get that to King of the World, Scott Anthony McCoy grandson of Austin McCoy,ASAP !!! At 3633 Landa St. Los Angeles California 90027. If I'm not there give the keys to Brian Decker. God Bless !!!👑🌎🙉🙊🙈🙏🙏🙏

@chuckdock4436 4 ай бұрын

5.7 ls...? typo?

@garryhern2908 5 ай бұрын

Have you not used Exi Outs.

@rubenvasquez021 5 ай бұрын

I know this video is a little old but what motor mounts did you use? Or did you guy fab up your own?

@dianepirtle5332 6 ай бұрын

Why did you cut anything off the t-case you only needed to shorten the transmission output shaft

@kylemilford5968 Ай бұрын

He wanted to maintain maximum overlap between the two for strength OE has 2 inch overlap, if he cut it all from the output he would be left with under 2 inches of mating surface

@stevanaeastwood8059 6 ай бұрын

Wicked

@cornbinder1970 6 ай бұрын

Where did you get drive line adapter from bbc to ls flywheel?

@shaunphillips2961 6 ай бұрын

When he says big block dorks 😡 then gives the actual estimates on speed 😂😹cool build though sure it’ll catch on even if all the smaller boats an LS will hold up in are going away

@Zionslayer1 7 ай бұрын

How much for the rail and mount kit? That website does not work.

@user-ro2vj1jm4n 7 ай бұрын

Question, how is the drive setup on the flywheel? what all did you make/fabricate

@squarefour1 7 ай бұрын

Kool project and great outcome.

@WarHorseBronco 7 ай бұрын

Do you want to sell this unfinished project? Asking for a friend named Blake W

@amandaa5254 8 ай бұрын

Have yous ever lost your gloves at acting stool

@bullhead360 8 ай бұрын

⬆️Big Block Dork lol

@corymelvin2030 8 ай бұрын

Excellent work. Came out sick!!

@bernardosracing5872 10 ай бұрын

could you explain how you did fuel line connections with factory Ford line , so anyway you video is great

@vinceloizzo5155 11 ай бұрын

Glad he specified He didnt kiss lol

@rjfnanaimo4203 11 ай бұрын

It’s called cosmo black

@VSCOH Жыл бұрын

DeBoss Garage has a boat he needs help LS swapping! 🛥️

@DIARRHEA-PANIC Жыл бұрын

00:38 I like how you were gonna say "fat guys" until you saw your fat friend looking back at you.. 😅😅😅😅

@UncleJoeRacing Жыл бұрын

We should race

@catfisher420 Жыл бұрын

Where is your heat exchanger? Or how are you getting engine temp where you need it?

@catfisher420 Жыл бұрын

Fuel pump should be powered from the oil pressure sensor so the fuel pump only pumps when there is oil pressure.

@catfisher420 Жыл бұрын

You need to do a speed density tune with no o2 sensors.

@flamethrower5794 Жыл бұрын

Big block dorks? There's a lesson in manners in your future, kid.

@DIRTCINEMA Жыл бұрын

We have big block boats too so we are the dorks.

@PEPE211606 Жыл бұрын

There’s also a lesson in learning a sense of humor

@keithridlen7122 Жыл бұрын

I just bought a jet boat for a project, I have a couple LS motors in my barn. Can you make a video about parts needed/budget required for this build? I have an idea but you've already done it so...

@DIRTCINEMA Жыл бұрын

Great idea! I’ll get one together!

@soffenbecher1 Жыл бұрын

I have a question about the fuel system. I am using the same type set up in an 94 Ultra but the way your is set up is the reverse of mine. It looks like you are putting the fuel in the outlet side of the filter. Is that correct?

@DIRTCINEMA Жыл бұрын

Good catch! I did have it flipped! But I swapped them over when we were turning it over on first start up

@randomname4726 Жыл бұрын

Came here from Deboss Garage. Nice job, engine looks really good with those pipes.

@autovationFtWorth Жыл бұрын

Nice job! Lovin' y'alls content. I played around for a long time trying to get my throttle to work without the pedal being super stiff and couldn't get WOT . I ended up using a bell crank kit from speedway motors, made it a lot easier. Here's my build kzfaq.info/get/bejne/a96eis9os5--d6M.html

@DIRTCINEMA Жыл бұрын

Thanks! Yeah we still are playing with it a bit we had to adjust it on the water. I’ll check out the kit from speedway

@travtech1 Жыл бұрын

No cam swap..... you were so close to it....

@okielicious Жыл бұрын

Well how fast ??? Lol.. I say 62 mph..

@adamformanack318 Жыл бұрын

😎💯✌

@justinolesen6192 Жыл бұрын

Wonder if them boys use them gloves while eating out of there inside bowls 😂😂😂😂😂 Can’t watch these two

@DIRTCINEMA Жыл бұрын

Yes we typically wear bi+#% mittens but still end up with dirty and cut up hands everyday 😂

@DEBOSSGARAGE Жыл бұрын

That was a fun watch boys!

@DIRTCINEMA Жыл бұрын

Thanks for the fun times!

@richbosch9564 Жыл бұрын

I really wish I could have been more of help on this project, but our flight was leaving with or without us and apparently you wanted the 55 out of your driveway

@DIRTCINEMA Жыл бұрын

Glad she made it on her first leg!! And my driveway is open again 😂

@danielscinta4551 Ай бұрын

What happened to these guys?