It worked but the phone us charging very slow what should I do
@Hindsight10114 сағат бұрын
You can use a fast charger again, but if you're having issues, check in settings and make sure fast charging is on
@psfgtech22 сағат бұрын
Greatly explained, you saved me $ for handyman, parts for 2 about $30 , and a little patience, thanks 🙏
@covidcarl7480Күн бұрын
should retitle it the year. doesn't apply to mine but thanks for putting info out.
@Hindsight10123 сағат бұрын
@@covidcarl7480 good point I'll will
@luisg106Күн бұрын
@Hindsight101 What if nothing is draining out of the water heater even after opening up the relief valve?
@tradesifi2 күн бұрын
. After your advice about genuine Moen parts, I returned to the plumbing store and purchased the moen part replaceing the knockoff part and the leaking stopped
@Hindsight1012 күн бұрын
@@tradesifi awesome! Glad I could help
@bobmurphy72132 күн бұрын
Thanks, Man! Your tips are much more helpful than Moen's generic video.
@bringtherain15442 күн бұрын
I can’t thank you enough for this video!! I too don’t want my kids on KZfaq and telling them to get off of it just wasn’t working….but this will😂😂
@ItzKavinOP-ky9gj2 күн бұрын
I did it but now my phone us taking way longer to charge😢😢😢
@Destoryer3392 күн бұрын
Doesn't fucking work anymore.
@embazle3 күн бұрын
This was it, thank you. I put a small rag on top while bringing it mid way and used a clamp wrench to get the initial twist in. Then I let it all the way down and unscrewed it easily. Perfect video!
@Hindsight1013 күн бұрын
Great
@cjthompson76204 күн бұрын
Thank you so much, this is a lifesaver
@Hindsight1014 күн бұрын
@@cjthompson7620 welcome
@loveinu4 күн бұрын
Do you then switch to a fast charger after the generic charger?
@Hindsight1014 күн бұрын
Yes, you can
@Hindsight1014 күн бұрын
Yes, you can
@MonsieurButter6 күн бұрын
My plug just "disconnected" by itself and I can't seem to screw it back in. I thought maybe the thread itself snapped but I don't see the other half of the thread stuck in the chamber. Any ideas as to what could be wrong?
@Hindsight1014 күн бұрын
Sorry not sure
@MonsieurButter3 күн бұрын
@@Hindsight101 all good thx for replying
@phobos_miner42886 күн бұрын
Best video on the matter. Thank you. Update: I change two (non-leaking) as a preventive measure as they were 15 years old. The Moen puller did work fine for me. Great advise to use the large nut of the puller and a wrench to pull out the first 4 mm out of the valve. After that a combination of pulling with the Moen puller while pushing with the finger on the valve, adding generously W-40 where the clip goes and moving slowly left and right (but only 3 mm each direction only to avoid that the unattached rubber fold if you turn to much), I manage to extract both in aprox 10 minutes each. Quite nerve braking. Thanks again for the video.
@Hindsight1014 күн бұрын
Glad it was helpful!
@AlyssaLauren-skits6 күн бұрын
THANK YOU BROTHER YOUR A LIFESAVER!
@Hindsight1014 күн бұрын
Welcome
@carlisaharper98736 күн бұрын
What happens when that still does not work
@Hindsight1014 күн бұрын
Not sure
@akseverson7 күн бұрын
This was immensely helpful, thanks!
@Hindsight1014 күн бұрын
Glad to hear it!
@rejeanpaquet43758 күн бұрын
I'm removing the Moen 1222 cartdrige and having problem, it's stuck, I came here for solution, i have the 1st tool and it's not working. I feel I need the 3rd tool but it's too much money for a 1 or 2 times use, but if I was a plumber I would get it, so easy. So I'm still looking....
@Hindsight1014 күн бұрын
Good luck
@vernongagne40428 күн бұрын
THIS! Thanks.
@Hindsight1014 күн бұрын
Welcome
@billnorris84578 күн бұрын
Well done! Thank you
@Hindsight1014 күн бұрын
Glad it was helpful!
@garymiller52638 күн бұрын
This is by far and away the best how to video I have ever seen and used on the net. No fluff, no filler, shot well, great angles views etc. Bravo my man. Thank you for this video.
@Hindsight1014 күн бұрын
Thanks for the comment
@BrainlessRace10 күн бұрын
Doing god's work, saving lives out here. Thanks man.
@Hindsight1014 күн бұрын
Lol welcome
@ahmedalgalby260711 күн бұрын
THANK YOU IT WAS DIRT ALL ALONG AND NOW ITS WORKING AFTER CLEANING
@Hindsight1014 күн бұрын
Great 👍
@maxansell675811 күн бұрын
These simple, clear to understand instructions worked perfectly. My spare Ford Explorer 2013 key is now fully programmed. I saved hundreds of dollars by buying a key from Amazon then getting it cut for free at Ace hardware and following these simple steps. Thank you Derek you're a lifesaver!
@Hindsight1014 күн бұрын
Good info thanks
@ramishkhan49511 күн бұрын
But what if i don't have the rubbing alcohol??😢can i only use simple q-tip?
@Hindsight1014 күн бұрын
Try it and see
@jeneldaculan272212 күн бұрын
June 26, 2024 Hope this works, will try later since mt hair blower is in the other house.
@Hindsight1014 күн бұрын
Let me know how it goes
@ash_158913 күн бұрын
I got a real problem rn so basically that does work but then after my phone is on it keeps on olaying a siren noise with the same warning and then shuts off again what should i do i need help asap
@Hindsight1014 күн бұрын
Not sure
@dallelo284913 күн бұрын
Can you do a video on how to put it back in? It’s hard to match the teeth with the motor when putting it back in
@Hindsight1014 күн бұрын
I'll see
@kamaaladiin13 күн бұрын
Eye glasses cleaner then dipped in a rice worked for me
@Hindsight1014 күн бұрын
Awesome
@Brawlerboi2313 күн бұрын
Didn’t work please help me
@Hindsight1014 күн бұрын
No sure
@babisilent15 күн бұрын
Would be great if Amazon would tell us we need to enable this feature on the !@#$! Firestick 😤
@Hindsight1014 күн бұрын
I know
@pgc4sean15 күн бұрын
Thank you!
@Hindsight10115 күн бұрын
You're welcome!
@Supersoccerchic16 күн бұрын
This only works if your drain doesn't have a screw in the middle.
@Hindsight10115 күн бұрын
Thanks for the info
@danielyi40716 күн бұрын
Thank you so much bro I got scared
@Hindsight10115 күн бұрын
Welcome
@jnbrumbaugh116 күн бұрын
Perfect! Thank you. You saved me from replacing the entire spout.
@Hindsight10115 күн бұрын
Excellent!
@lisahoneycutt419416 күн бұрын
The trim plate on mine is caulked to the wall. How do you get it iff?
@Hindsight10115 күн бұрын
You have to remove the caulk. It shouldn't be too bad it's not like glue
@mikem387516 күн бұрын
What do you mean "get it half way?" Pull it up half way, or turn it halfway?
@Hindsight10116 күн бұрын
Pull it up half way then turn
@mikem387515 күн бұрын
@@Hindsight101 I finally got it, thanks🙂
@richneilev17 күн бұрын
I only get the moisture detected warning when attempting to charge my Samsung Galaxy A33 when it is switched OFF! (I am able to charge it when it is switched ON).
@Hindsight10115 күн бұрын
That's odd
@BetterWithEditz17 күн бұрын
tysm man
@Hindsight10115 күн бұрын
Welcome
@GosWardHen9817 күн бұрын
Great info, Derrick. Clear, concise, and informative. Thanks 😅