The part you had a hard time with is a press fit, just give it a nice tugg and it will turn loose. The. To reinstall just line up the rubbers with the already installed hex bolts and push on firmly until it is seated

Nice video a lot of useful info 👍

Thanks great video

Thanks for the advice.

Can't you use Vaseline in place of dielectric Grease?,

I also have a 05 3.7 liter v6 dodge Dakota very useful

Now I will be doing this in mine!

Question about when reinstalling the spark plug wires from the 3 ignition coils, which wire on which ignition coil goes to which spark plug on the left side of the engine? I forgot to pay attention when removing the old ones.

Hello, I have unscrewed the spark plug but i cannot remove it because the socket is too deep. I cannot put my fingers in side to take the spark plugs out, how did you remove it?

I have the same truck. I change my plugs regularly. What happens if I gapped them at .035?Also what are the total number of O2 sensors? 2 or 4? I only found 2 of downstreams. I may have to replace them. Been there too long and at over 290,000 miles.

Why did you mention there is a air plug??

poor poor poor video if u speed the video faster,u produce a blur.

Question about when reinstalling the spark plug wires from the 3 ignition coils, which wire on which ignition coil goes to which spark plug on the left side of the engine? I forgot to pay attention when removing the old ones.