You helped me out a lot bro, mahalo! It was kind of hard to figure out how to get the light connector housing and TSS unit. Each one is a different style of clip. The light housing one on the driver's side is especially tricky, but I think it's done like that by Toyota because they have superior engineering, and they know that piece is almost going to be accidental defacto load bearing when removing the bumper, I know it was for me for a couple minutes.

Thank you so much for this video! Was very helpful when replacing headlights in my 2022!!

Insanely helpful thank you!

Props to you and Pops!! My 2021 is same as yours, I was loosing my Mind never seen the 4 screws. Thanks Again

Nice job explaining the process. Ty

You are a life saver! Thank you kindly!

Thanks for the video, I was missing the screws by the TSS.

Thankss for the video, very helpful, on the front sensor, I found it much easier to remove the 2 10 mm bolts to the bracket then going for the screws. just a suggestion, work well for me.

Thanks for the help!

You must be getting ready to put in your new headlights. I bought the Apex headlights (see thumbnail pic) they really set the truck apart from other 4 Runners.. I love mine. Mine goes through a start up procedure where they turn on and off in kind of a sequence of amber then white. Your truck is looking good.👍

Thanks again for another thorough demonstration as I'll be installing my new Fang lights w/switchback. Question: In the engine bay fuse box, how would you connect the fuse extender as mine (2023) the 10A INJ is on the first top row and not much room and prevents fuse box cover to properly close and seal? Thanks in advance for your assistance.

Looks like the front bumper sensor bracket has 1 10mm screw that will remove the whole thing?

It might be worth doing this to change your valance if your thinking of doing that. You can do it without taking the bumper off but it is a real pain reaching some of the clips that hold it. Also it would be easier to to but all the clips back on taking the front bumper off.

About to do my 2020 off road. Thanks

I’m stuck on the grille sensor disconnect. Looks like you have only one plug in however my 22 has two plug ins. One similar to yours and one that looks like it’s connected directly behind where that sensor/camera sits. Any tips on removing that is greatly appreciated

Bruh! Your better than me on that bu🤯🤯

Whole video is great except the sensor for cruise control. If you don’t know how to unplug it you’re going to struggle. Showing might have helped I’m currently stuck there. I’m sure it’s easy but when you don’t know you definitely don’t know

The 2 - 10mm bolts for the front system must be removed the bracket

Extra step in the front middle. Don’t have to remove that shirt harness

I would just get a TRD and call it a day