thanks Dan!

Thanks for posting this video. Once I realized I had to pull the weather strip out of the way to get to the "C"clip out (to remove the lock), it went together fast. Thanks! Kenn

Dan, I think you're right the anti-rattler goes up behind the window channel. Great idea to flatten that end, I wish I would have thought of that before I put mine; I'll try flattening it out because it is really tight on the window. I did things a little different. I already had my door latch in and adjusted. Next I put the division bar in first and just loosely put it in place. Then I put the anti-rattler felt in and then the window channel. Then I put in my the vent frames. According to the manual the division bar needs to be loose for all of that including putting in the window regulator. Which is what I put in after the vent frame. The vent frame is the only thing, besides the door latch, that I have tightened down. I'm at the point of trying to bed my door window into the window channel roller. I have my door glass up in the division bar and the rear window channel, so its wedged in between those channels and the anti-rattle felt; I can still move it up and down or back and forward. Good video!

Great videos. Thank you for posting

Dan, where is Part 6?

I own a 56 f100 and the process should be similar

Have a 1956 Beater here!!!

That's why I never fully tighten something until I get it all fitted up.

Where is Part ^6 ???

Im having a tough time removing the remote regulator. I have the window all the way up but I cant get the handle shaft pushed in enough to slide it off. Any advise?

Can not find part 6, either it was pulled or never uploaded.