Thanks for the followup!

If the joint was cracked I agree with derekeckhard8836, but if there was a hole in the condenser, then time to get a new condenser. IMO if the filter drier is installed before the service valves(upstream of them) and the leak is not in the condenser, then you do not have to replace the filter drier since it doesn't get exposed to the air. IMO, In that case, you just need to close the liquid line valve, pump the refrigerant into the condenser, being careful not to go over the coil test pressures, close the suction valve after you feel you've pumped as much refrigerant into the condenser as you're comfortable with, recover the remaining refrigerant, make the repair, pressure test for leaks with nitrogen. Then pull a vacuum with the aid of a micron gauge down to at least 750 microns, isolate the pump from the system using valve core removal tools installed on the service valves(always remove the valve cores when pulling a vacuum, it makes the process much faster), leave it sit for about 20 minutes and after that if the pressure doesn't rise over 1,000 microns, then you're good to go. Nice work, by the way. However, you didn't use nitrogen while you were brazing, which, IMO, is a must. Lots of copper oxide forms inside the lines when you don't use nitrogen, it could plug up the new filter drier or the metering device. Also, make sure the inner cone of that oxyacetylene flame is either neutral or carbonizing and not oxidizing( it shouldn't be pointy, this will tend to melt the copper).

Nice work!

We will put the whole part into the water which help us to repair it easily. In some case, we will also use some thing which can make bubbles.

Nice video ty. When my outside heatpump (acunit)starts there is a loud mechanical sound that worries me . Do you have any idea of coarse. Ty for a y help

Hey Josh, why didn't you just repair the leak on the old condensor coil? Sweat it, resolder it, etc. Then put some of that insulation tubing around it and call it a day?

What swaging tool was on the drill?

I hope that the metering device is either a piston or a bleed type TXV if your pulling the vacuum from one line.

Great video 🔥 just to clarify. There was a leak in the coil. That was causing the condenser to short cycle. Keep it up 👍

Great Tutorial ..been hvacing for some 30 yrs & never have replaced an condenser coil ..Yet but headed out to an Trane unit later today , that might just need new coil replacement ? ill find out soon enough ..Thanks for all the heads up

Great job Josh where did you get your torch handle?

Good video

Quick question, ac works fine at night but during the day it does not cool we are at 94 degrees down here in miami. Opinion please

👍👀🇺🇸

How much you charge for that repair ?

it’s very different way to repair the air conditioner. In China, we usual check where was the hole instead of renew the whole part. I also have an another question, how much the customer paid to repair the air conditioner 😂😂😂

Great job Josh where did you get your torch handle?