@bankspower this dude did you a favor and made a dope install video for us 12 valve guys!

Side note this is the most helpful diy video I've ever seen on KZfaq

So far to date for me the most informed video for manifold install . Also thanks for the tip on valve cover gaskets . Will not tell you how long it took me to get those last two in the back !!!

I am new to the Cummins ,and this is a great video.. Lots of step by step

Best explanation! You just got another subscriber 👍🏻.

Best video I’ve seen and all well done

Haha everything below is what I was thinking. Best install on the banks twin ram. Subscribed 👍👍

Nice video, I like all the fine details!

Nice, just bought one of these. 👍 definitely

Planning on this and their intake on my 98 in the near future. Hopefully will work with my future plans too

I blacked out that gray plastic on my bumper it looks sweet after

I love the cummings....great power

One thing I would add is, immediately after removing the intake plate stuff a couple clean shop towels in each intake port on top of the valves. Then some clean rags in the bottom of the intake manifold. You do NOT want ANYTHING to fall down in the cylinders. Once the gasket surface is clean and you're ready to pull the rags out I like to run my shop vac while I'm slowly taking the rags out.

Nice install and I agree with Richard, definitely the most informative video on KZfaq regarding the install on these. Did you notice any gains with it?

18 FOOT POUNDS!

Pusher intakes makes good shit

Great video. I bought a 98 12 valve with this banks twin air. I’m having issues with the grid heater not working.

So you cheese 🧀 wiz the gasket to the cover gotcha

How did you clean off the gasket?

The thing Im worried about is whether or not that silicon you added to your valve cover gaskets is heat resistant? What kind of mess are you going to have if it isnt?