How’s the clarity on the upper magnification ranges? Really considering this for a tikka I’m picking up.

Burris just need to allow the scope or the app to automatically pull data from a kestrel or laser rangefinder, hopefully they build that in or if you have internet on your phone at the time it can take environmentals automatically in and adjust

My experience differs. Started in January 24, a couple hiccups in setting up but great customer service. Sighted for 100. Then set the scope to 425 yards in the heads up display. Read the setting on the turret and the MOA was way more than either my Strelok or Hornady 4dof app called for. Shooting Hornady 147 ELD M in 6.5 PRC. Called customer service and they could not explain. Asked for all my settings, sent it to them. Their response was that I could not use the G7 ballistics, I had to use the G1 numbers. An update would be available in a few months. G1 worked at 350, but the was off at longer distances more than the G7 in my other apps. Last trip to the range to confirm, the heads up display was faint and hard to read, as I sat down to shoot at 350 the screen went blank and I set the turret to the earlier adjusted MOA as when the scope worked. Missed 2 straight. Scope came off, my vortex razor went on and next trip, 3 dead center hits. The batteries only lasted about 30 minutes total and was turned off immediately after each use. It should be back at Burris now and when back will go on a varmint rifle, if it dies again I will be close to home and not 2,000 miles away.

I am loosing my mind with this scope, after zeroing the rifle 100m then you zero the digital zero is the heads up display meant to change to 100m?.. I must be a dummy ?? 🤣🤣