I twisted a ball of 5m 0.25mm nichrome wire and placed it in the combustion chamber to expand the heat zone. Fuel vapor burns better as it passes through the high temperature zone. The effect was staggering. The fuel supply had to be restricted as it started to fail due to overheating. An aquarium metal tap had to be installed to limit fuel supply by 50%. Then the output has a 143c airflow at 1.6Hz and with 5l running in 27h in my variant. The fuel burns so well that there is almost no smoke from the exhaust pipe, only weak steam. I suggest you give it a try.

I turned mine off and turned it on again after it ran out of fuel and it fixed itself 👏🏻

I just had E8 troubles, opened up the combustion chamber and found it insanely coked up. Cleaned that out, put it back together and it runs better than new..

Had same issue but I ran a bit of compressed air through the intake at startup and IGNITION happened...plus a ton of white smoke but at least I didn't have to open her up. I ran it on lowest setting without running at high for the first 3 months and now know not to forget to burnout the soot with high for a couple of hours once a week. Had 6-7 failed starts with err #8

I’ve one off these doing the same thing every time I top up or fill the diesel tank, I’ve found it seems to get air locked ,I pull off the pipe from tank to the fuel filter, blow out the pipe and away she goes. Hope it helps

Thank you sir. I'm over here looking at everything but the fuel level. 🤦

In frigid weather is sludgy diesel a likely culprit? First try use low-temp additive?

Sounds like a vent problem on the tank.

When you crank it full it’s needs more fuel the filter being so close to the machine starves it a bit try moving the filter near the fuel tank so it can’t suck air in from the filter housing 👍 it might also be your fuel line inner diameter is to big and your loosing pressure through the pipe

Wouldn't be the exhaust to short it's fuel from the tank the filters that come with these heaters mark are crap put them in the bin filter from other end and just a thought is your fuel tank able to breathe so it not vacuuming are settings right fan speed pump settings ?

Hose from pump to heater make it short as possible

the filter should be inches away of the fuel tank this will help

My fuel pump had a airlock , I held it on a 35 degree angle and it started working

Maybe the hole inside is closed up and needs cleaning 😉

It work sometime but most time erorr 8 ni gud

Türkçe yorum istiyorum.E hata kodları ne anlama geliyor.lütfen türkçe video istiyorum.plase langue Türkçe.