CRAZY Stick Drift Calibrating Fix Playstation Xbox Controller

Рет қаралды 7,165

Жыл бұрын

This stick drift kit by ExtremeRate allows you to calibrate your drift stick issue, allowing you to fix your drift every time it occurs. I recently installed these stick drift kits for my PlayStation 5 Dual Sense controller. Since the Xbox uses the same joystick module, it can also be done with XBOX ONE or S. This does require some soldering so make sure you have a soldering iron ready when attempting this fix. You can also watch my other Drift Stick video to show how to clean the potentiometer to help with stick drift. Thank you for watching and visiting my channel. Make sure to subscribe and I will see you on the next one.
15% OFF KONTROL FREEK WEBSITE: glnk.io/3vlxq/Gamer2Know
Playstation Warranty Repair DualSense: repairs.playstation.com/s/?lo...
Backgrounds in this video are from: www.vecteezy.com/
Website to measure joystick reading: www.gamepad-tester.com
ExtremeRate Stick Drift Kit for Playstation: amzn.to/3TnKZqm
ExtremeRate Stick Drift Kit for XBOX: amzn.to/3FZOe4n
Analog Stick Module Cubes: amzn.to/3xRlgi7
Potentiometers: amzn.to/3RcD4Lm
Soldering Iron w/ HeatGun: amzn.to/3liQCrm
Flax Paste Syrgine: amzn.to/3N2UfNJ
www.extremerate.com
10% Promo Code: GAMER2KNOW
Gaming Accessories and Mods
#stickdrift #playstation #fixstickdrift

Пікірлер: 20

@ArthurShelby-PB Жыл бұрын

I picked up some off AliExpress. Do I go for 50k or 10k parts?

@bigdmc6459 11 ай бұрын

Lol just done this worked great. As luck would have it I bought 1 kit to see if it works I had 2 faulty controllers . 1 kit fixed both as I had a left and a right faulty. £15 bargain. Did rip a L2R2 ribbon cable so back to eBay for a new one lol. It’s like paper be careful lol

@danielm4136 3 ай бұрын

So basically, I had to get a new Ps5 Controller after my old one got stick drift on the right joystick. I’m currently using the new one , But I still have my old one that has drift. Was thinking about getting this mod (even though I’ve never done soldering before) and give it a try. I’ve seen some people say that it doesn’t work well and only increases the dead zone. You commented this 7 months ago, is the mod still working? Did you need to go back in the controller to re calibrate again? If so, how many times?

@bigdmc6459 3 ай бұрын

@@danielm4136 both my controllers are still working without fail never had to adjust it. I use it everyday for a couple hours best £15 I ever spent. Soldering isn’t to difficult don’t over think it just put it over the pins and heat up with iron. It will work.

@danielm4136 3 ай бұрын

@@bigdmc6459Lemme know if you have instagram by any chance… looking for knowledge on this

@assowdg6980 Жыл бұрын

btw is it like just changing the dead zone and does it fix it like factory new because if you use the stick drift calibration kit is it smooth like new?

@moneyboy503 Жыл бұрын

Long story short, the potentiometers go bad normally over time and don't report centered as material is removed, this device tells the stick, wherever it is, where center is. you control that with the screws, From what i've read. it's not an actual permanent fix. you can calibrate multiple times as the potentiometers continue to wear down but once there's nothing that can be tracked whatsoever you will need to replace those which will require some soldering

@zZiL341yRj736 Жыл бұрын

How good is this? Does it work long term and how accurate is it?

@TheGamer2Know Жыл бұрын

It works, just takes some time to do it and you have to be very careful. A lot of room for error.

@catpersonality66 Жыл бұрын

Man, you are a lifesaver, I have had some drift problems lately and think of buying a new one cause I never had an idea that I can fix it myself using a tool like that. Thank you Man and I will give it a try

@TheGamer2Know Жыл бұрын

Thanks bro, check this video out it’s a lot easier method and cost less. kzfaq.info/get/bejne/pNh-oduU2LzLqmw.html

@catpersonality66 Жыл бұрын

@@TheGamer2Know What's the differences between these two fixing kits? 🤔

@TheGamer2Know Жыл бұрын

@@catpersonality66 I only mention one fix kit. The other way is to clean or replace potentiometer

@omermax3859 Жыл бұрын

Do video about r3

@TheGamer2Know Жыл бұрын

Thanks for the suggestion. I will look into it

@omermax3859 Жыл бұрын

@@TheGamer2Know I appreciate your effort and time and thank you

@twatik 4 ай бұрын

CAN ANYONE TELL ME, is this just deadzone adjustment OR does it actually fix the joystick being inaccurate and makes it symetric? Cuz if this just adjusts deadzone its a complete waste of money😂

@bigdmc6459 3 ай бұрын

Once you fit it you calibrate back to center using the the controller calibration site. Works a treat

@roasty80 10 ай бұрын

Misinformation. This does not fix stick drift permanently. The potentiometers will continue to wear on the stick and will eventually need to be replaced

@moneyboy503 10 ай бұрын

Misinformation would be him saying it was a permanent fix. Knowing anything about how and why sticks wear down would tell you that. This is a fix and a working fix. It's added another 4 months so far to a 3rd party controller my dad uses that only lasts about 4 in the first place.