Damper Rods/forks- VintCo Vintage Dirt Bike Tech Tip

Рет қаралды 5,652

2 жыл бұрын

Joe shares his tips on Damper Rods/Forks for your vintage dirt bike. VintCo helps get you back on track and keep the ride going. Visit us at www.vintco.com/ for your Vintage motorcycle parts.
Check out Joe Abbate at / joeabbatescycletherapy with his Vintage Q&A show.
#vmx #vintagedirtbike #vintagemotocross

Пікірлер: 9

@wernerdriver4996 2 жыл бұрын

Great knowledge thank you

@internetpolification Жыл бұрын

Thank you for this. Much appreciated

@BlueliteBluelite-lu4oh 2 жыл бұрын

Great content. Keep it coming. Thanks.

@bobhannah9944 Жыл бұрын

I always machine new dampner rod piston rings -most of the kyb, showa parts are no longer available-and alwayas replace the springs on the old 70's/80's bikes

@baundule8246 11 ай бұрын

Hi sir, I need a suggestion, if I change my damper rod with a bigger one and wholes r same like the stock one, will it increase the hight of the overall suspension as well as the travel? Or if I change the bigger spring with the stock one do the same?

@Near2Future Жыл бұрын

I need a tool to remove my damping rod. I have a MT07 do you happen to know where I can get one?

@Cheezeball99999 3 ай бұрын

If I know Yamaha, and yes I realise this comment is a year old, it'll probably be about four feet worth of 1/2" socket extension.

@Near2Future 3 ай бұрын

@@Cheezeball99999I just put spring back into it. Then compressed it to put pressure on the rod. Did it on carpet for better traction. Also needed to heat up the bottom screw as it must have had thread lock.