Hey there Tim. Hoping to start this engine up later today. Tomorrow the latest.
@sts.5563 жыл бұрын
hard work i know , respect my man.
@JoesBusBarn3 жыл бұрын
Hey there green tips. It’s coming to an end my friend. Should be starting it up tomorrow
@nelizte3 жыл бұрын
Nice job 👍🏻
@JoesBusBarn3 жыл бұрын
Thank you for your comment Nelizte
@jasonradomsky48272 жыл бұрын
Love the videos Joe! What kind of oil do you use for your dt466s?
@prospexican Жыл бұрын
great video, it must have thousands of likes, thank you for sharing, question, does the head bolts have to be new if not overheating been done to motor?
@JoesBusBarn Жыл бұрын
I have re-used the same head bolts on a few assemblies but it is recommended that you do replace them.
@user-ln7of9gs4s3 жыл бұрын
I always wondered why they never installed jake brakes on smaller block engines, and 'm not referring to exhaust brakes either.
@JillianLatorreTS2 жыл бұрын
Hey Joe, I have a question on how child check systems communicate with buses. How is the system actually connected to the CAN bus and programmed, so it can control lights and interlock with the ignition?
@aleosso45378 ай бұрын
Installed the head after replacing the cam,lifters, and double dog bones. When filling the coolantit is leaking just about the entire length of the head the right side. Do you think it's because of the aftermarket gasket or stretched head bolts?
@yonysaborit19482 жыл бұрын
how much torque
@yonysaborit19482 жыл бұрын
how much degree
@terrellscaife2411 Жыл бұрын
I’m wondering would this torque sequence work for the 1979 DT466
@oglazy64772 жыл бұрын
Hey,are those head sequence the same for a 2004 dt466?
@JoesBusBarn2 жыл бұрын
Not the same Og Lazy. Similar. I’m working on an 04 right now. I just started tearing it apart. I’ll respond with the sequence you are inquiring about in a few.
@oglazy64772 жыл бұрын
@@JoesBusBarn ok thanks I'm rebuilding my 04 df466 and need the head sequence
@einarreitz3571 Жыл бұрын
Hi Joe, I'm replacing a dt466 head and injectors..the sleeves and piston look good. Do you check sleeve protusion on every block...I don't have the hold down clamps for checking protusion...but I was thinking of just putting grade 8 bolts with washer to hold down the sleeve. What's your views on checking protrusion?
@Ben_Diesel_Diagnostic2 жыл бұрын
Take off the Lifting hoist you have more room for your torque wrench