Simple but brilliant design, thank you for sharing

Ive seen another video where the guy had a sliding rail for the front wheel. He put the front wheel into this ( like a bike courier van putting front wheel so it cant topple) and then just pushes the bike in. Thank you fir sharing your excellent idea.

Bloody brilliant, thanks for the inspo

Brilliant idea mate🎉Thanks for sharing 👍👏

Gives me all the information I need, thanks for sharing 👍

Great idea this, have been thinking about building a lean to on the shed for my XJ6.

Is it difficult to get out of the enclosed space you built?

Great job. Found this whilst looking for a temp solution for my 2 bikes whilst I build my garage/garden room at the back on my house (on to a private access road). May well do the same using your helpful video. I did have a thought on your set up as see at 4:48 there a view down your side passage to the rear showing the stepped block and brick-coped party wall that also recesses in narrowing the width of that gap further. I wondered if it swapped out for a thin fence that followed the middle line of the lower front wall if that would give enough wiggle room (and it would probably mean a wiggle!) to get your bikes down the passage? I imagine you considered this and may not have or want the garden space fo this anyway but just a thought. I'm also currently obsessed with groundworks (as part of my learning on myh project) and note that a very tidy cement base you have there out front!

I think I would use dome headed coach bolts rather than screws to build this excellent project, and maybe locks at top and bottom to stop thieves twisting the door open? However this is just what I need as I am stuck for space with no room for a normal size shed. Thank muchly!!!

Have to build something similar for my xj6 too.. 👌👌

Very nice idea, once I get our back yard a bit further in order I'll be making one (though slightly adapted) cause my bike has a kickstand and also I'd make it a bit bigger around the bike. Still thinking of ways to reduce extreme heat build up in summer and condensation. Guess some further out walls at the top and more inside walls at the botten with a wide enough overlapping gap and some mesh wire could do the trick to stay dry while allowing plenty airflow.. but it would probably not look as aesthetic as your design.

Easy to get the bike in and out?

Hi pal, how much did all the timber cost?

You have used a security hinged lock but left door hinges exposed...

cool

Maybe add a tire frame to hold the back wheel so bike is upright when backed in .. I dont think I would want my bike on the side stand for long periods :) .This is very helpful though .. I might try to figure out working from a stable long wall with roof and frame to back bike in put on center stand then close three hinged doors (Two for the open long side and one for the end you enter from ... All held together by framing ... I would make it a bit taller so I could back the bike in sitting on it and be able to get off .. and out ..

I paid to store my new moto in a friend's garage last winter here in the U.S. North East. So this is interesting. I'd like to see something of how you get the bike in and out of the shelter. What's more, my moto has a center stand, and takes a little bit of rocking motion to get it up on the stand. So I'm curious how you maneuver in the space.

Can always scale it up if you want

Hmmm🤔 kinda looks like someone could just tip it up from one end and they'd have a new (to them) bike. Maybe a floor? That would also allow the weight of the bike to keep it from blowing against the bike in a wind storm.

Do you think putting small vents in would help to reduce condensation/moisture build-up issues?

Daft question, but how do you get it on the stand once the bike is in place?

fear of head bump.

How much was the total cost of materials? Just bought a ninja 650 and rent a duplex. Need something cheap like this to store it securely.

Where are you based? Can you build one for me?

Looks like an absolute pain in the ass to get in and out of. No way to get in to grab the bars to walk it back out

Terrible drummer, was the music home baked also.