Рет қаралды 410,342
I got asked many times to share the method I used to make these Moon Crater Cuffs, the bracelets I made out of copper tubing. So here it is, the long-awaited video tutorial! ;)
It's not hard to make the air chasing bracelets, it's just a little time-consuming. If you follow my direction here, you will soon start making them too :D
If you enjoy my tutorials, Buy Me A Coffee: www.buymeacoffee.com/popnicute
BUY THE FINISHED BRACELET HERE: www.popnicute.com/mooncrater
Basic Tool list: kaysommers.blogspot.com/2016/...
Tutorial Level: INTERMEDIATE.
Tools List:
- 6 inch copper pipe - 1/2 or 3/4 inch thick
- Anvil/steel block - amzn.to/3pS652n
- Chasing/ballpeen hammer - amzn.to/3tBvG1V
- Nylon hammer - amzn.to/3jm6gjK
- Dapping punches - amzn.to/3aCem44
- Small embossing hammer - amzn.to/2YKERPl
- Cross peen hammer (optional) - amzn.to/3pQuEwH
- Chasing tools/design stamps (optional) - amzn.to/3tsHlzH
- Steel step mandrel - amzn.to/3tDUcPU
~~~~~
- Torch (Mine is a propane torch) - amzn.to/3aDexvJ
- Soldering blocks - amzn.to/3rqYnwC
- A bowl of cold water (to quench hot metal)
- Copper tongs - amzn.to/3oRRbI7
- Third hand - amzn.to/3q3iv7m
- Pickle (PH Down) - amzn.to/3cHeDoU
- Baking soda solution (to neutralize pickle) - amzn.to/39PJttO
Subscribe to my KZfaq channel to get notified when I'm live.
👉 / popnicute
Follow me on social media:
👉 / popnicutetutorials
👉 / popnicute
👉 popnicute.com/subscribe