You deserve way more views then you are getting, I know you don’t full time KZfaq but you should promote your channel a little more, love the vids.

i had a lot of health problems have lasted couple years but am back working some but really enjoy and glad i found your channel plain and simple to the point hope you never change your approach to you tube

Cool what a revival, so much content, great presentation of perseverance good job (yea those settle reminders check the lug nuts) - Priceless. Total enjoyed the front end alignment my dad taught a similar method but need another body to hold the tape measure. LOL

Good morning from Cape Cod ⛵ don't apologize for the long video, it was very cool to see that F-250 just sitting there as a pile of junk turn into a viable tow rig. That could have been ugly with those loose lug nuts, yeah s*** happens. Thanks for an awesome video Ron, man keep up the great work 👍✌️🇺🇲

As always, I love to see how u make old junk great again 😊

I very much enjoyed the longer video it was an awesome video good job Ron!

I like how casually you problem solve

Happy to see a new Misfit Toys Video!! Very Underrated Channel IMO!!

Loved the video, the longer the better. Looking forward to the next one 👍

May of been a long one but it was very interesting 🤔 as well. Thanks for sharing 😊.

Great stuff!! I once did exactly the same thing with the rear lugnuts on a car.....completely restored an old MGB and on the first trip it was doing the same.....both back wheels were damn near felling off. Live and learn......

I got a 1996 f150 4.9l and it’s runs great when cold you can fire it up in the morning and drive it anywhere but as soon as you shut it off and go to restart it she fights it’ll fire off but surges and shakes the whole truck you gotta give it gas to calm it then it runs fine

146k ain’t bad at all, I had a 97 F-350 single wheel 4x4 460 5 speed that the odometer quit at 352k. Spent most of its life plowing mud through pastures and pulling a triple axle stock trailer. Its ultimate demise was when the seat broke through the floor because it was rusted out and became too scary to drive 😂 460’s are tough. It might not have got the fuel mileage, but it would out pull the 7.3’s of the day, and start easily in the cold.

I'm not familiar with the MT 90 oil that you put in the transmission but check the manual. I think you'll find that the ZF5 uses a thinner oil because of their inherent tight tolerances. Thanks for the video.

many years ago mid 1970's i gave $650.00 for the Snapon Ball Joint remover kit its so odd present day mostly use my Harbor Freight ball joint tool much easier to use. good thing about it though the adapters will interchange. will have to admit the Snapon is a much heaver duty tool but never found joints the Harbor Freight tool doesn't work just fine

Good video!! And good editing!! I know it took a long time to make it but it was very good!!

Either fill the radiator with white vinegar and run it until it's hot flush with water and it should be completely clean or get toilet boil cleaner with rust remover from the dollar store 4 bottles and the rest water and do the same thing run it get it hot drain it it will definitely be cleaned after the toilet cleaner

We had an 87 f350 2wd 460 with a 4 speed it was a good truck it had an RV engine that only had 40,000 miles on it The truck towed a 19,000 pound mini excavator or a 25 foot dump trailer no problem until it lost oil pressure. Cold it only had like 7 psi and once it warmed up it went to zero and the lifters started tapping

Maybe its because its a chevy but when i cut the bed bolts off the old 78 k10 they did the same thing with the punch but didn’t hang up the bed could be because there was hardly any rails left as well

IT appears that the truck has a ' trailer tow package ' because of the one ton springs, overload helper leafs. and a rear sway bar. my also account for the 4 : 10 gear!

I got 93 f350 idi dually automatic.. $2.5k

I like the long format videos too. That mint green wheel bearing grease, I've not seen that before. What was it?

Thats called a spout connector...the egr can be the source of pinging, btw. Does it have a cable speedo ?..if so pull the cable out of the sleeve and grease it.

loved the tool on your hip... texas ... ?

Like your mom! 😂

I got 93 f350 idi dually automatic.. $2.5 k