DO NOT use white teflon tape on any fuel fittings!!! Fuel will break down white teflon tape and you’ll be left with a white goo and a fuel leak. If you must use teflon tape, use the yellow teflon tape (it’s gas resistant). Though with teflon tape, you run the risk of a piece of tape breaking off and possibly clogging an injector. You’re better off using Aviation Form-a-gasket Number 3, as it specifically states solvent resistance to gasoline.

Bro I like the videos you put out im from nj too

Stuck at home wish I could come over and help you since i have nothing to do at home..Be safe keep the videos coming

Very good Instructions ✌🏽

That was a good video I didn’t know ktune fuel rails nice might have to get one for the crx one day

Very informative thx bro

I’m saving this I already have a Ktuned fuel rail but didn’t consider other methods to run. Might want to go the way you are.

Radium also sells the fitting to run the gauge on side

Thanks!!!

You are not running a return fuel setup?

Does your fuel gauge needle shake alot when the motor is running?

Can you use stock injector clips

Hey ! How did you remove the long bolt and replace it with a regular bolt ! Please send me the bolt you used to replace the long one for the passanger mount on min 11:08

What is the advantage over the stock except for the looks. It will have a fuel saving?

What about fuel regulator?