Lid Lock bypass fix Maytag whirlpool washer
Рет қаралды 3,745
Жыл бұрын#maytag #whirlpool
@kingstonday3345 10 ай бұрын
thank you. this is an on & off problem for me on a regular. this is the only video that made sense & that i could comprehend as a non mechanical person. thank you
@cartalk5585 10 ай бұрын
I haven’t used the bypass in a while myself. I have on occasion had to bump it with my fist when it is time for it to engage the lock. I have taken my finger nail and pulled the little plastic plunger out and pushed back in multiple times. Recently I have also had some trouble with the plastic plunger not disengaging at the end of the cycle. I have bumped it with my fist on top of the door but above the lock and it disengages.
@johnniewilliams5371 9 күн бұрын
Must use this piece every time tho so place with in baggie ANF with wash utensils bleach or whatever you have and boom!
@johnniewilliams5371 9 күн бұрын
Thank you, but just remove the lock part from the lid and place in the hole it works fine goes thru all cycles. Put in safe place and that's it no wires cut just remove 2 screws that hold in and place inside like it would normally look close lid if like or leave open and it will work fine.
@davissunglasses Жыл бұрын
After tricking the switch for a while it’s back working normal again. I have hit it with my fist on the lid about the time it is supposed to trigger, and that has worked also at times.
Braincatchers
Рет қаралды 14 МЛН
Bens Appliances and Junk
Рет қаралды 300 М.
Consumer Appliance Report
Рет қаралды 44 М.
Appliance Repair Shorts
Рет қаралды 70 М.
KiKiDo
Рет қаралды 2,9 МЛН
ExtraordinaryAmor Bro
Рет қаралды 8 МЛН
НУРДАУЛЕТ & АДИЛЕТ
Рет қаралды 201 М.