А манжеты,интересно,тоже какая-нибудь контора штампует из переплавленых рваных тапок?))

Зачем шток закрасил?

It always amazes me how these guys have all this skill to do all this mechanical repair work yet none of them seem to know how to build a damn table for the work to be done upon

And...that right there, gentlemen is where your Harbor Freight bottle jack is produced! 😂

He was caught red handed! 🤣 Everyone seems to be commenting about health and safety but don't realise that sometimes nothing matters apart from putting food on the table. This man is doing what he needs to do to survive

Даа,просто поменять резинки.Но зачем он шток покрасил???

Всё в песке и земле хотябы верстак себе сделал.

Руки не докрасил🤣. А так 👍👍👍 хороший ремонт!

Обслужить домкрат много ума не надо, а без ремкомплекта невозможно :)

I always come for the comments with videos like these, and I am never disappointed.

did nobody noticed that he also painted the pressure cylinder?

He is the Jack of all trades ✅

Imagine if these guys had a real parts washer at their disposal...

This man doesn’t jack around! He is good 👍

Вот они где настоящие слесаря 👍👍👍👍👍👍👍👍👍👍

Skill full Pakistani long live Pakistan 😊💪

ох эти любители покрасить шток

Good on him, just trying to make it like everyone else 👌🏻

what surprises me the most is how clean his clothes are with the dirty work he does is incredible

Rozebrał, umył w syfie, poskładał na tych samych uszczelnieniach i wlał stary olej. Normalnie brawo.

And not a single oil spot on his clothing. Amazing! 👍

These clever industrial people are the real environmentalists re use most things time and time again,,,, respect

Great video. Better to reuse and recycle or repair rather than dispose and replace. Very impressive rebuild. However afew concerns. 1) Once disassembled and cleaned he should have used the wire wheel on every component including the base. Or sand blast everything except the piston shaft. Then polish with the wire wheel and compound. Then he should have hung up all the individual componets on a wire then spray painted everything except the piston shaft. Then reassemble once components are dry and paint cured. Lastly it is not wise to apply any paint to the piston shaft. The piston needs to be left as a polished bare metal surface. Then lubed with oil. As the shaft goes up and down the paint will break apart and will wear out some of the seals prematurely and worst still paint chips can become stuck inside the bottle and contaminate the oil lubricant. This can lead to prematurely failure. And when it comes to bottle jacks prematurely failure can potentially cause death or serious injury. Otherwise very good build. I too was impressed with how clean be is and how clean his wardrobes were throughout the entire process. Even his hands were pretty clean. He definitely is very skilled.

Great job, no nonsense attitude on this.

Красавчик! Видно что на совесть делает

Fighting the life with great skills, feeding the family probably. My respect.

That guy is a craftsman. Good job.

ماشاء الله تبارك الله لاقوة إلا بالله وفقك الله لكل خير ورضي عنك وفتح لك مغاليق العلم في هذه المهنة الشريفة 🤲🏼👍🏻👑✅🏆⭐🥇

Never mind the incredible mechanical genius. How does he “sit” in this pose for so long?

The best part is how he uses a spraygun to squit paint all over the thing, while touching the wet paint constantly. You might as well use a brush at that point...

Great craftsmanship, and there was a time in this country when we made products that could be rebuilt and reused before we became the land of aplenty so now it all goes to a landfill! Was there ever really a Sears and Roebucks? Or was it just a fantasy like Camelot on a hill?

Молодец мужик, на коленках сделал и все работает!

He takes pride in his work. Good job sir

I like the grinder sitting on the tire.

Respect from a worker from iran

I wonder how much they cost and how much profit is in one.

I need to sell work tables in this dude’s country. How much more efficient he would be if he was standing! Kudos to this Cat! True Badass!

A happy man doing what he knows best

Awesome right up to the spray painting 😂

If everbody got back to buying quality products that can be refurbished at the end of the life cycle land fills would be much smaller.

Bu zor şartlarda sanatını konuşturmak bu olsa gerek vallahi sonuna kadar helal olsun🫡🪂

My back hurts after watching him sit on a toddlers seat at a work bench that is essentially a floor. Trueley experienced craftsman.

Ремонт выполнен отлично 👍

La sculele pe care le detin acesti oameni sunt niste genii!!!!

What a great video! Not a lot of us repairmen left in this disposable world. Skillful attention to detail. Well done my friend.

Nice that he used the old oil.

He is master of his trade. We can make out how perfect he is in his work.

جميل فعلا أحسنت صنعا عزيزي ربي سبحانه وتعالى يباركلك ويوفقك دائما مع خالص تحياتي وتقديري واحترامي

The. Brilliance is not that he kept his clothes clean or could squat for hours on end, but where the hell did he get the seal kit???!!! Let alone the right one!!

Iam impressed, this skilled individual could do this in his sleep..great video 👍

The amazing part isn't the work or completed product. The amazing part is how these people squat like that for that amount of time!! That's amazing.

Nothing so unusual about the repair. Finding the proper seals to withstand the pressure is. This repairman is organized. He scans for worn parts What is amazing is that the jack is made to be repaired at all. 🎉

Hard working, talented man !!!

This guys always restoring things i wish we had guys that near me to restore things like that

Узбекистон Привет Нарманли

These men can reuse and rebuild anything!! It's fken crazy. I need to get my damn skills up. Even me having these Milwaukee and crazy tools I don't come close too these guys!

I learned how to remove roofing and then installed roofing for 35 years with very few companies. Same principle. Enjoying this video!

Прямо за углом сидит чувак, занимающийся покраской, чуть дальше чувак, который печёт резиновые кольца, слева за зданием чувак, который делает всякие клёпки, чувак, который делает молотки потом чувак который выпаривает соляру и тд, не говоря о чуваках, которые качают воду, электроэнергию и тд.

😂 😂 😂 There are 3 chairs to the side like at the barbershop: you go in, wait, pay and then come out with the repair done right 👍 👍 👍

Надо отдать должное мужику,при всей той грязи в которой он это делал,все же он старался промывать детали перед сборкой.

I just think about what these people would be capable of if they had proper facilities and tools. The world would spin a lil faster.

no fancy tools at all! this good man...knows his stuff!

They should sell them in pairs, a Jack and Jill. Adorable❤

أحسنت 👍👍تابع ❤🇩🇿 بالتوفيق إن شاء الله

How did I get here? And I watched the entire video 😄 If I saw him during a holiday I would have walked on after 10 seconds.

Skills 👌🏻😎

Вижу пакистанца в тапках перебирающего 30тонные домкраты - неглядя ставлю лайк👍

Knows his jacks that fella 😎

He’s gonna crazy when he figures out we got gloves and closed toe shies

I was wondering if he was gonna paint it. He knows his way around a jack and a snack.

Mantap dongkrak yang kuat 👍👍👍👍👍👍

Thank for sharing knowledge.

Gasoline with water back to earth .Very ECOLOGICAL . Bravo

What shocks me is that this guy can make a living fixing jacks in a little street side shop.

It looks like it was rebuilt many times.

🇮🇩 mantap brother👍👍👍

Fast worker. He knows his craft. Protect your eyes, sir, when using the grinder.

Imagine all that skills , and proper equipment, steel toe boots, gloves and a good working table!!!!

Ver good, mister

5/5 for work safety, especially that oil resistant robe, goes very well with fast rotating stuff.

Trabajo perfecto el del reparador pero fatal el del pintor !

The lack of basic human safety gear makes me sad. This video is amazing to see and I enjoyed the process but it physically hurts watching someone use a wire brush without eye wear after seeing what it does to someone's eye. Those chemicals have a VERY real and serious effect later on with repeat exposure. Raising my glass to all the heros out there who are getting the job done even though it likely means injury and suffering later on. I'm sorry.

Good job 🙌

Уникальный метод, но почему они всё делают на корточках, ведь удобнее всё делать за столом-верстаком, оборудовав единожды своё рабочее место.

Какое масло используют в этих домкратах?

Why do they hate benches. Surely the bloke next door is making some out of old coke cans.

Excellent work ! 👍

شكرا لك على الموضوع المميز والمفيدة

These jacks are rated like 2,5,10,20 tones and so on. A while ago bought two 10 ton jacks. Tuev „certified”. CE sign on other shit. After first use and far away from 10 ton load, one started to leak and compressing back. While its made like shit, it costs 20€. While you can't repair it desently for that price, it goes to scrap. Thats called competition, but its not to increase quality, its for reducing price. Not many people will pay 50 € for jack, which will work for life, but many will pay 20.

Чувак живёт в домкрате, ест домкраты, ему снятся домкраты, и жена у него - домкрат.

Wowwww super!!!!!!

Muy lindo trabajo.!!

Nice job even painted his hand red

It's always nice to see a mechanic doing his thing without ruining his clothes.

COMO NUEVO 👍🚘😎

While watching these videos from Pakistan i always think a work bench would be nice

Bravissimo il meccanico, il verniciatore lascia a desiderare.

He might want to try cleaning up his workshop once in while. Especially the immediate area where he he is re-building the jack.

Эти ребята умудряются на коленке выдавать качественные вещи не хуже чем на заводе 😊

Great work wish to employ somebody like him