MOST COMMON - Polaris Ranger Problem - Front Differential Axle Fix - Replace

MOST COMMON - Polaris Ranger Problem - Front Differential Axle Fix - Replace - MUST SEE

Рет қаралды 110,888

5 жыл бұрын

In this video we are diagnosing, removing, and replacing the front differential on a Polaris Ranger 700/800 4x4. Quick and easy - MUST SEE.
Check out the complete rebuild as well: • Polaris Ranger / RZR /...
CV Shaft Banding Tool: www.ebay.com/itm/233375848420
Front Boot Kit: amzn.to/36SD7J1
Boot Kit: amzn.to/3iT39y2
Service Kit: amzn.to/35O8FPg
Impeller: amzn.to/2IOVyot
Top End Rebuild: amzn.to/2UNjL0v
Blade Kit: amzn.to/3kSYQ6I
Fuel Pump: amzn.to/3pMoC0i
Watch more service videos on the Ranger:
• Polaris Ranger RZR 700...
• MOST COMMON - Polaris ...
Mid Nebraska Motorsports YT
PO Box 23
Central City, NE 68826
VENMO is: @midnemotorsports
Check out my eBay store at: stores.ebay.com/midnebraskamotorsports
Shop for parts at: midnebraskamotorsports.com
Instagram: / midnebraskamotorsports
Patreon: / midnebraskamotorsports

Пікірлер: 51

@CraigArndt 5 жыл бұрын

Nice work.

@vanatoj 3 жыл бұрын

Which video explains the cv joint replacement? I couldn't find it on your page.

@shelleydetournillon7216 Жыл бұрын

can i just remove axles and differentials and bolt the tires back on until i can find the replacement differential

@blake-802 7 ай бұрын

I have a question for you guys I just bought a 2005 Polaris ATP 500ho I bought new cv axles I noticed the old ones you can slide them out very easily I haven't taken them out yet I could slide the CV axle almost out of the differential with no resistance is that normal both boots are completely gone on the old CV axles and I got oil leaking down on both front tires I bought the wheeler on Facebook market.

@armedfarm3429 6 ай бұрын

Just take out the diff, remove the side plate bolts & replace the worn parts, it's a very simple drive box, once you have one apart you can swap in new parts & have it back in the machine in a couple hours.

@MidNebraskaMotorsports 6 ай бұрын

Copy that. I'd agree. Thanks for the comment and for watching. Let us know if you need anything! www.ebay.com/str/midnebraskamotorsports

@johnwalsh8316 Жыл бұрын

I removed, and installed the front differential in my '12 Ranger HD from the side. Nothing removed except axles and hubs. No need to remove the duct either. You can slip the differential in carefully.

@fourbyfourer Жыл бұрын

I done the same as you, just slid it out the side. I didn't remove the duct either.

@kickapookayaker 11 ай бұрын

Make a video

@324bear 2 жыл бұрын

After watching this video, I have a question. My 2004 4X4 Ranger 500 seems to have a bind when turning tight. It acts like the 4 wheel drive is engaged. I've put the machine on jack stands and then put it in each gear both with and without the 4 wheel drive engaged. When the switch is off the front wheels don't turn.

@MidNebraskaMotorsports 2 жыл бұрын

Sounds like a bad CV joint. Check my video on that!! kzfaq.info/get/bejne/mriTZcRpl82Yd3U.html Let me know!! Hit the subscribe button so you are notified when more videos come out on the Polaris Ranger. Thanks for watching.

@324bear 2 жыл бұрын

@@MidNebraskaMotorsports I by golly Am subscribed! Thank You for what you're doing and for the video link too!!! As we're inundated with rain the next 24 hours here in east central lower Michigan, this video will be my next project!!!

@josephthomas7034 2 жыл бұрын

should you hear the front diff engage when selecting 4wd or will you hear anything?

@MidNebraskaMotorsports 2 жыл бұрын

Nope you typically won't hear anything. Thanks for question. Have you watched our full rebuild video: kzfaq.info/get/bejne/hLyTgdhzzruwdps.html

@MrDausen 3 жыл бұрын

When these splines are worn badly, does it make a clink sound when hitting bumps?

@MidNebraskaMotorsports 2 жыл бұрын

That sounds more like a u-joint. It could also mean bearings. Let me know what you find. Thanks for watching.

@mrwhamisrick 2 жыл бұрын

When I had clicking in the front it turned out to be that the prop shaft was dry where it goes on the front differential.

@clintsabatier6194 6 ай бұрын

How do you repair the steel that holds the front diff?I need to weld and fix cause holes are torn

@MidNebraskaMotorsports 6 ай бұрын

Are you talking about the steel frame that you install the diff to? Or the actual differential itself? The frame, I'd find a good machine shop the help with that project. The differential I'd check out our ebay store to find a good housing or differential to buy. Thanks for the comment and for watching. Let us know if you need anything! www.ebay.com/str/midnebraskamotorsports

@mrwhamisrick 2 жыл бұрын

When the splines get work and sloppy does it cause driveline vibration at higher speeds?

@mrwhamisrick 2 жыл бұрын

Worn. Not work.

@MidNebraskaMotorsports 2 жыл бұрын

Sounds more like bearings that are going out. Any noise?? Let me know what you find. Thanks for watching!

@mrwhamisrick 2 жыл бұрын

@@MidNebraskaMotorsports Bearings in the spline hubs?

@stumpfarm3714 2 жыл бұрын

How many miles or hours did you have on the Ranger before replacing the differential?

@milkman69x 2 жыл бұрын

5600 kms / 2 years for mine

@armedfarm3429 6 ай бұрын

Miles has nothing to do with it, it's all about what it was treated like during those miles.

@adrianjoelgonzalezvazquez4885 2 ай бұрын

Whats the ratio of the differential

@warwickadams6108 Жыл бұрын

hey mate love your videos could you please put a link or tag me in the rebuild video I can't find it

@MidNebraskaMotorsports Жыл бұрын

If you don't see it on our channel. Hit that subscribe button. We have hundreds of videos yet to come! Thanks for watching. www.ebay.com/str/midnebraskamotorsports

@bearbait2221 3 жыл бұрын

PACK SPLINES WITH ULTRABLACK TO KEEP DIRT AND WATER OUT WORK LIKE A CHARM

@mrwhamisrick 2 жыл бұрын

What is Ultra black?

@bearbait2221 2 жыл бұрын

@@mrwhamisrick silicone

@pepejaramillo909 4 жыл бұрын

What oil of diferential

@pepejaramillo909 4 жыл бұрын

????

@1ajs 2 жыл бұрын

when moving does this make the front end noisy?

@MidNebraskaMotorsports 2 жыл бұрын

You shouldn't hear anything unless you have a front end going out. If you hear a clicking and ticking, it might be axle shafts. Thanks for watching. Have you hit the subscribe button?

@1ajs 2 жыл бұрын

@@MidNebraskaMotorsports more like banging noise

@StarD435 4 жыл бұрын

Mind telling us the pricing of replacing these supplies?

@OmarRodriguez-xu3lz 4 жыл бұрын

Better to rebuilt it!! An way way cheaper!!!

@jaywhitney7929 4 ай бұрын

There's an easier way? Jack buggy completely off floor Pop Dr side upper bj and lower shock bolts. Pop axle out of diff. Psgr side do the same but also take axle stub nut off. Pop axle out of diff and remove. Put buggy in neutral, crawl underneath, and with one foot rotate rear tire to line roll pin with hole in floor pan. Long punch and drive it out. Pull 4 mounting bolts. Reach thru gap left by axle and disconnect wires and breather tube. Rotate diff on its side, pulling it away from rear drive shaft Slide diff thru gap left by missing axle. Takes about 20 minutes

@MidNebraskaMotorsports 2 ай бұрын

Can you send me a video! Thanks for the comment! Let us know if there is anything we can help with. Check out: kzfaq.info/get/bejne/jpZxl6mp0LDNf5s.html for more tips. And: www.ebay.com/str/midnebraskamotorsports for all your parts.

@jaywhitney7929 Ай бұрын

I'll try to send you a video but I'm not really set up for stuff like that. I have to pull it again for the fourth time. It keeps intermittently locking the front diff as if in 4wd. Doesn't matter if electric is hooked up or not.

@A-mechanics-review-4U Ай бұрын

@@jaywhitney7929wyf