PA03586-K983 PA03586-K984 Feed Exit Roller Compatible with S1500 fi-6110 N1800 S510 S500 fi-5110C

Рет қаралды 16,229

3 жыл бұрын

Warning: In the process of replacing tires, please don't use excessive force to damage the tires！！！
If you need a whole set of in-out paper rollers for S1500 S1500M FI-6110 N1800 scanner, please order from the following link:
www.amazon.com/dp/B0BCVRY3ZJ
If you only need feed & exit tires of fi-5110C fi-5110EOX fi-5110EOX2 fi-5110EOXM fi-6110 N1800 S1500M S1500 S510M S510 S500M S500:
www.amazon.com/dp/B08P4CC48C

Пікірлер: 18

@jamesaltomare2510 Жыл бұрын

Thank you thank you thank you. Fitijsu said my s1500 is no longer repairable. I located rollers and Amazin and although it took me 8 hours, much to my disbelief my scanner is working again. I never could have done it without your video. Hey, I had only o e screw left over. Not bad

@outsta 7 ай бұрын

Maybe you could share how to remove the sides?@@jareksimek-sm9xj

@AuntKdances Жыл бұрын

Thank you VERY much for your tutorial! I was hesitant to do it myself, but took it to a Repair Cafe event, and some of the volunteers were able to fix my scanner using your video. It did take a while, but it is working again and I couldn't be happier.

@user-jl5nq7iy6f Жыл бұрын

Great！It is my honor to help you!

@user-jl5nq7iy6f 4 ай бұрын

That's great!

@notesanom9546 2 жыл бұрын

Good tutorial working for scanner fujitsu

@user-jl5nq7iy6f 2 жыл бұрын

Thank you so much!

@minniegirl5460 Жыл бұрын

Thank you so much for this tutorial. How long would you say it would take a "regular" amateur person to replace the rollers like you show in the video?

@user-jl5nq7iy6f Жыл бұрын

Half an hour!This is the first time we shot when we disassembled the scanner!

@ColourboyBlack334 4 ай бұрын

Okay...so I bought the roller kit with the rubber already attached, placed them in and reassembled the S1500. I am still getting a hum/stop/hum and the paper barely going in. So is the problem, I didn't beat the rubber tires with a mallet? Any advice would be greatly appreciated.

@user-jl5nq7iy6f 4 ай бұрын

Friend,Please check all parts to ensure that they are installed in place! If the paper cannot enter the scanner, plz check the pick roller!

@ColourboyBlack334 4 ай бұрын

@@user-jl5nq7iy6f I actually tried, but it still rolls and sticks rolls and sticks then after 3 tries, it says paper feed error. It seems as if the melted rollers still have residue i missed in the exit roller housing. As the paper tries to go thru, it seems to stick to the new rollers too. Once taking a closer look i have noticed sticky residue on the new rollers, could that be my issue? if so what is the best way to get up that remaining residue in the exit roller bay?