As a former metal worker.... This was actually horrifying to watch. Watching a baby seal getting clubbed is probably less horrifying.

Using a worn 3 jaw chuck is a recipe for certain run-out. Nor did he use a DTI to test for axial alignment. Misalignment would cause an increase in torsional vibration and risk crankshaft failure. The flywheel would also need re-balancing.

I can see that all that work is for nothing as there is another crack in the flywheel plate that can be seen clearly.

Abbiamo appena visto tutto quello che *NON* si deve fare in questi casi,potrei capire un simile spreco di tempo solo nel caso il ricambio non fosse più disponibile,ma in quel caso avrei agito in modo totalmente diverso,cominciando dall pezzo filettato che avrei realizzato in ghisa e non acciaio (lo stesso materiale usato in origine),lasciamo perdere concetti come equilibratura e precisione che sono evidentemente ignoti al "tornitore" dei miei stivali...

Я думаю эти ребята прикалываются .. делать нечего, вот и строчат видео из серии техноужоса😅😅😅

Japani Bhi ye jugar Dekh ker dang rahjatay hongay Zabardast ❤

Q forma de trabajar ,sin las mínimas reglas de seguridad , El soldado de la volante se hace toda la pieza en caliente ,y no como lo calientan el sector a soldar

He'll be repairing a broken crankshaft next week. Just because something can be done, it's not always the case that it should be.

The only thumbs up this video should get is the people that did it in the video.

Ok Apu, here's the flywheel, you see it broke off for some reason. Yeah, material quality was not a problem... Like I said - no reason. And don't mind the huge crack across it, just fix the center.

Obra de arte meu amigo, vcs são magníficos. Um grande abraço do Brasil.

I'm still waiting on the "shocking" part. LOL

MY GOD, so manny reasons to say NO. Back yard machineing at it's worst.

Like 1❤❤❤❤❤

Ouch!!! Bouncing heavy parts and the 3jaw on the ways?! Must be the company’s lathe and not his.

The flywheel is a non-breakable part, but the broken part is special, and it seems more economical to replace it with a new part than to repair it by welding.

👍 from Uruguay ,🇺🇾

Good thought.

Good job Guys ;oP

just look at the crack in that flywheel it's a waste of time trying to fix it

А ведь кто-то поведется и начнет думать, что так на самом деле можно восстанавливать...

Stonehenge repair, not balanced, never be same, get new part.

wow amazing work

nooooooooo dont electric weld a component when the path to ground is throught the lathe headstock bearings!

Very skilled, professional machinist

Адская колесница

That flywheel has a big crack and might split apart.

well, done no safety glasses!

~0.01mm ?

You are an extremely able machinist.

3:48

This is satire, right?

What country is this? I guess pakistan

5+

ITS A SIDE SHOW JOKE!

warantee,nope

Yes, SHOCKING is the key word! click bait for a useless part

это порнуха