If you found this video helpful please do me a favour and hit the LIKE & SUBSCRIBE buttons 🙏🏾

Nice one! Changed one last week, had to disconnect gas valve, disconnected DHw and Flow pipes to get it out! Nightmare. Doing another one tomorrow, il use your method

I found this out the hard way the other month! Great video mate for those who didn’t know!🎉🎉🎉

Another great informative video CP. not sure why people are saying its easier to take it out the front with pump and block out disturbing miltiple connections. This looked pretty easy to me. Well done mate.

I bet that looked great on the schematic for whoever designed it. Reminds me of years ago we got invited to see a new “design” for an appliance for a certain manufacture I work for. Up on a jig on wheels looked pretty good. Until we looked at the back, and the screws for the plate had been installed from the back. Meaning the entire thing would have to come off the wall to work on… room when quiet when that was mentioned.

Brilliant trick on the plate , Great video as always, 👍👍🤜🤠

Nice bro I didn't think you could drop it down on the ERP's so thanks for sharing! I think if the pipes run up the back you'll be struggling to drop it down like that though, block out job they're not too bad when you've done a few! Take it easy mate 👍

To activate the air purge on the ERP boiler Press [return/spanner] and [tick] both together until Menu 1 is displayed. Use the hot water up or down arrow until Menu 2 is displayed then press the tick button. Use the hot water up and down arrow until 2.2C is displayed then press the tick button Use the hot water up or down to select 0 = air purge off 1= air purge automatic 2 = Air purge mode on

Happy days, will be doing that next time. Top tip 👌

Nice video again!

Nice tip chirag thank you❤

Great information thanks 😊

Have one of this to do today but not sure if that’s the fault with it. It overheats and shows 100 degrees but still cold water comes out. shows e9 276 code Changed temperature sensor and check the flow sensor but the boiler kicks in when hot water is being used

Thank you for the video

Bro mine is having loud noises like a chopper (vibration ) sound and it suddenly stops hot water supply as well so what would be the problem there do you have any idea?

I would put it in air purge for a few minutes menu 2 I think 2.2c

That was surprising that it was quite a new boiler and had filter and limebeater but still blocked🤷🏼‍♂️ you’ll be glad to know the cdi compact has 1 screw holding the plate and it comes out the front👊🏼👍🏼

Do you recommend replacing sycron motors?, or just replacing the whole actuator?, if the teeth on the actuator lever have worn out then replacing the motor won’t really help in my experience, replace the lot and be done with it?

Hi Chicago just been watching your videos and enjoying them how did you start in boiler repair.

What causes these HE blockages. Is it the system water or the mains water deposits in Hard Water areas

You mentioned that you watch videos like this to learn. Can you recommend a few channels to follow/watch?

I prefer taking the whole hydro block out, taking it out is easy, putting it all back in can be a pain because you need three sets of hands, take it all out and replace prv and plate seals, replace all valve washers and flow and return seals, prevents recalls, cutting into pipes, creating stress and strain on connections whilst trying to speed things up, sometimes it’s quicker doing it the long way if you know what I mean?….

Should.always replace the o ring on the return and supply manfold

Would clean the plate and use for back up for next customer if they wanted a refurbished one.

When will these “boiler designers” just spend a few days on the front line…….?

Waste of time.faffing about, it's easier just to remove the pump assembly and take it out through the middle.