A "How-To" for designing successful windings with the X-Winder 4-Axis filament winder
Пікірлер: 10
@BluesDoctor9 жыл бұрын
Turner, outstanding quality presentation. Looking forward to upgrading mine to 4 axis.
@mahrezaitm.51622 жыл бұрын
Amazing illustration of filament winding. How did you get the mandrel out of the pressure vessel? Have you considered a thin liner in your tank design? Thanks very much.
@MrJhuber6 жыл бұрын
Can I use for building elbows?
@taylorinase80944 жыл бұрын
How did you pin the filament lead to the mandrel prior winding?
@Addmaster1Ай бұрын
Where can I buy the software? Are their already winding pattern preinstalled
@GavynPendleton5 жыл бұрын
how do how separate the winding from the mandrel with a 4 axis print
@coleajluni92062 жыл бұрын
I'm dealing with bunched up ends on my winds, is there anyway to fix this
@NSAwatchesME7 жыл бұрын
very good :)
@ezesirito8 жыл бұрын
Hello Turner, I've been trying to contact you regarding the Xwinder but I can't access to Xwinder web page
@treelimb486 Жыл бұрын
Amazing how collectively bad these instructions are.