😊

Thanks

Very nice!

thank you

5:27 you show a pneumatic cylinder here. Although pneumatics are considered “fluid power” this is a hydraulic cylinder in this instance

4:42 electric motor is the “prime” mover. It can also be a diesel engine, gasoline engine etc.

1:45 this is also called the “sump”

Now I understand how the piston valve work 😊 thank you so much

Congrats. So good, easy to understand

I understand 👍👍👍

Excellent

helpful thanx

ı would like to ask one question.we have two high shov and lov shov this valve firstly read tank pressure and compare the set pressure then make a pressure control based on the threshold.we want to use withput proportional valve or samrt valve is it possible to use with just on and off valve ?

Thank you very much, what about current consumption at 20% for example? It will drain a lot of current as it stays at steady level the coil of the solenoid valve will work too much isn't it?isn't more convenient to use a servo motor with an MCU to control a standard valve in water applications?

Thank you so much

what if both work simultaneously ?

It is very good

Excellent presentation , for me it was a great review

Happy for what I learned

Thanks 🙏

Superb

great Ms. PNEUMATIC..

Thank you very much for this professional work of explaining easily, precisely, and effectively.

What if we use automatic pressure control in the compressor? Do we still need an air regulator??

thank you very much dear

can you please tell where can i find these products

I have a 25 ohms) proportional solenoid valve that uses 200mA-700mA (to operate. I am trying to find a driver or a signal generator for it. Please advise

Sangat membantu...terimakasih

These videos taught me more in around an hour than an official course that took around 20 hours within 3 days.

What a great explanation and animation! So, with a double-acting solenoid valve, the cylinder's rod can stop at any position between the maximum and minimum stroke. But, a single-acting solenoid valve only has two stop points. Is that right?

In calculation why pressure has plus 0.1 and divide 0.1 please explain the conversation

@ms.pneumatic Possible to hire you to consult a prototype we are working on?

you are the best maam thank you so much

Thank you for the easy to follow videos. If left solenoid is on having the cylinders rod in the out position and then left is turned off without turning on the right side the rod would stay out since there wasn't a signal to moves right sides plunger right? If so would it be because the left plunger stays left from ongoing pressure from hydraulic pump or would the left plunger go back to the right creating equal pressure traveling thru both sides of the pilot hole?

I've been sent here by my engineering teacher

Good explanation

Fantastic video! Thank you so much!

please make video for air consumption in on-off valve & control valve

Thanks

When booster valve is in Stop condition or reaches predefined level then why one of drive chamber need to vacate?

Well explained

So if pressure increases when restricted to feed the second cylinder, wouldn't pressure decrease back to 5bar once it enters the second cylinders large area? Making it pointless?

非常好

Very good information 👍

I've been watching some of your videos , you are very good teaching! Thanks for information. 😁

Where do we prefer single Solenoid and Where do prefer double solenoid please tell

These are phenomenally useful videos. Thank you!

Very much interesting really the the study of hydraulics is interesting

Very much interesting i have injoyed your explanation about how really hydraulics works

how can i order that kcc pv ? i have been in the website but there was no information about how to order it