Thank you. I searched and searched for a clear visual. Your video covered everything I needed.

Thank you for sharing this video. Helped me change mine on a 2007 Honda CRV. Mechanic told me the problem was the AC Clucth and would cost $800 to fix. After looking into it myself (not a car expert by any means) a see that the blendoor was stuck. Mixer/Actuator was not moving anything, saw your video, bought the part, replaced it, and now both the AC an Heater work good!!

Thanks for taking the time to make a video and help others. I did not think I would be able to do anything about it myself until I found your post, and it was for the same car. Amazing DIY era we live in. I’ll share one pointer to make the job a little easier. I did not have to touch the four screws to loosen the feet air duct. I just manually removed the panel surrounding the vent as explained in the video, and the gas pedal. Unfortunately for me, my problem was not the air mix actuator, but the mode control actuator. I should have done more research. Plus, I ended up with an engine light for “Check Emission System”. My guess is that it’s because I turned on the engine while the gas pedal was disconnected. I’ll need to find a way to clear it.

Great video helped me get part changed out. A national repair shop wanted over 500 to replace the actuator. It took me a few weeks because no one had part in stock. Part was 65 and took about 30 minutes to replace. Mine is 2009 Honda CRV and I only removed the gas pedal and was able to access the three screws. Your video showing to remove gas pedal saved me hours of frustration. Once this is done very easy access to replace part.

Thank you so much! I just changed this part out on my 2010 RDX and I have heat once again!

Great video, thank you very much. 2013 MDX, did not have to remove pedal assembly or foot duct. But I was prepared thanks to you!

Thanks dude. My RDX 2011 blowing front only. your video helps thank you

Great job...I heard someone say that you have to take the dash board out. After your video, there is definitely no need for that. Thanks again!

ok,thats better, only vid i could find that covered all bases, excellent work chap

Thank you for the heads-up very helpful I'm working on a Honda CR V EX 2012 great video

Thanks!!! Saved me a few hundred bucks.

F*#k! Yes! I just did it thanks to your video. Previously went to a shop because my heat wouldn't turn off. about $300 later they fixed it. I looked at the invoice and the part was for a passenger side actuator. I had no idea this crap was in stereo. a week later I realized all I could get was heat on the driver side. And I needed AC! One would think that the driver side might just be a little more important! HA! Thanks for the help! You rock!🤩

Thank you. I have the same problem with my 2011 crv. I will attempt to fix it now. Thanks.

I want to thank you so much for this fantastic video. I had the same issue in my car, and I replaced it yesterday. After replacing the actuator, it didn't work well, so I collapsed 😂 then I did some Google and found that after replacing it, the new actuator needed to be calibrated as well. So I just calibrated it, and it worked well.

I know this is my exact problem on my 2011 RDX. My local shop was able to un-stick the blend actuator last Fall when the heat didn't kick in. So, of course, when we went to turn on the heat this year it didn't work. So, I'm gonna swap this out. If you went inside the guts of the part you replaced it is likely either some teeth on the gears are worn or the 12 VDC motor is shot. That comment from the person on the $800 charge to replace the AC Clutch for this issue is a typical car stealership or shady shop deal.

Thank you my friend. I have same problem on Honda CRV 2010. I will try to fix it like you.

Muy instructivo el vídeo! Tengo el problema de que en mi Honda CR-V EXL ,al poner la calefacción, sale aire caliente del lado del acompañante pero del lado del conductor sale aire frío. Deduzco que debe ser el actuador que no funciona. Gracias a tu vídeo, me animo a desarmarlo para ver si se puede reparar o cambiar por uno nuevo. Saludos desde Córdoba,República Argentina!👍👍👍

Dude you are awesome because that’s exactly what my problem is in my 2010 CRV. Out of all the videos on KZfaq your video was the only one that said exactly what the problem was the fact that you have warm air on the passenger side but only cool air on the driver side. Your video was awesome very very very helpful

Thanks for your help identifying this repair

Great video, it made my job very easy

Thank you for sharing your knowledge.

Great video although this piece does not determine your blower function or the speed of it. It starts rotating when you raise the temperature or lower the temperature on the driver side when in dual option. However the video is great and I did use it for reference to replace my actuator 😁😁

great video! after watching I see I don't have any of these damn tools to DIY so gotta find someone to do it..

Very very helpful video…thank you bro..

Thanks. Excellent Instructions. Ken Duff

Miss the days when you just pulled a knob in and out...

Great video thank you for your time

Great video Thanks so much

That’s the control for heating vs cooling. It switches between hot air and cold air. This does not seem to affect which vent the air comes out of. This doesn’t change the air flow from, for example, your feet to your face.

GREAT VIDEO, THANK YOU

Good video help me to do this job, thanks

Good job

Thnx dude.

Any idea where the passenger side actuator is located? I have heat on the drivers side but not passenger

All the videos show easy removal ,no one shows the hard part reinstall Alineing the cam with the rotor !

i have 2016 hyundai santa fe xl with 119k, i have an 8 month intermitten very low air flow out of the vents with cold or hot air. The blower motor works on all speeds but no air comes out the vents, i have already replaced cabin filter...what could be causing this

Great job dude, I have the same issue for a Acura RDX 2014, Driver side. I looked underneath and it looks a bit different. would you know where can I get a plan of that area that instructs how to remove it?

Reallt appreciate the video. My mode door actuator also crapped out on my. Is that seen just right about the blend actuator?

Very good

I noticed on the one you pulled off had lube on it (the white stuff?). Did you have to lube the one you put in and if so what kind? I'm not sure if my motor needs to be replaced or just re-lubed, it makes sounds like it's opening a portal to the underworld when it's on. And it kind of seems like it getting stuck, but not sure.

Good I like it.

Good job homeboy. The presentation was excellent. Only problem with video was the sound keep going to whisper level. Other than that very informative. Thanks.... 👍😎

I heard a whining noise coming from that so I disconnected it and no more sound. I also hear some sound underneath the center console. Is the noise from the rear blower?

Thank you I would like to see you work on a 2009 Volkswagen CC because that what I have if you I would really appreciated thank you.

For some reason, on my 2009 RDX, the blend door actuator wasn't getting power. I just unplugged it and cleaned the connectors a bit. After plugging it back in, it starting moving normally again.

I wish you showed the installation.

hey do drivers and passenger sides have their own actuators? I have the same problem but on my passenger side! asking for an 09 civic

Cars are great. They still make parts or at least you can find them generally. My carpet cleaner couldn't turn the brushes, so I took it apart. Worn out plastic gear that they do not make any more. What so I have to throw it in the landfill.? Plastic gears should be illegal. I could have had it working! Frustrating I hate planned obsolescence.

Hey man many thanks for the information is very helpful, is there other online store where I can purchase this part from? The one you left on description discontinued the part. :/

I have the same problem but when my A/C is on the driver side will blow hot air an the passenger said will blow cold air

So I recently replace that part on my 2007 Acura MDX, however the driver side still blows hot air while right side and rear blow cold. What am I missing?

Hey can you help me where the location of the drl relay under the driver side? Thanks

Hey guys does part does this ticking sound then go away? Mines only happen on start up behinds glove box. Also no AC/HEATER on at all. It ticks for less then a min then go away. Car is 08 RDX

I watched your video before and I missed removing acelater pedal

Can a blend actuactor not turn fully, i have a lack of hot and when i turn ac a lack of cold its coldish but not as it meant, when i touch the pipes from the ac are freezing but not from the wents, same as the hot its not that hot , so i thoght the mixer ot close hot/cold fully, can it be that prob? and i notices as the engine warms up it get a little mild the ac.

Got a video on replacing blower heater resistor?

I don’t get air to the windshield do you think is this the problem? My hot and ac works perfectly on both sides I just don’t get air to the windshield

Can u also show where is the passenger side actuator pls..

What is the motor not moving prior to you replacing it? Both of my motors move on the passenger and the driver side yet I’m still getting cold air on the passenger side when I put the heat on

Quick question, how do you place it so that it correctly goes on

Is this the same for a 2012 acura tl?

cara cek aktuator sudah rusak bagaimana?

man can't hear you

That's the mode door actuator not blend door

Thanksssssssss ILY.. 😝

Good job