Changing pump on baxi boiler 105 he

Рет қаралды 10,774

5 жыл бұрын

Пікірлер: 26

@wivaquif 3 жыл бұрын

When I changed mine I simply isolated the boiler from the water system and radiators , then release the water pressure in the boiler. Nice video, well explained.

@handyjayes1 Жыл бұрын

He can charge more if he takes three times longer

@sweetypie697 Жыл бұрын

@@handyjayes1 lol come on that's uncalled for lol

@handyjayes1 Жыл бұрын

@@sweetypie697 that's what 'con merchants' do

@aftermath3127 Жыл бұрын

wouldnt recomend that on older boilers the valves can leak then you have 2 problems to fix but baxi 105 s have a drain off on the boiler dont know why he didnt just use that

@wivaquif Жыл бұрын

@@aftermath3127 . Yes I used the release tap next to the overload valve. 2 years on and still going strong, when I can afford to put the heating on 😂

@CurvedSlightly 4 жыл бұрын

Nice crimped flexi there, mate.

@stonearches2883 4 жыл бұрын

Thank you for posting this. You are a great help.

@davidhanlon9325 4 жыл бұрын

Thank you

@teamninja30 4 жыл бұрын

Thank you for demonstrating, it will be a great help

@michaelwelsh 4 жыл бұрын

Did you fix it ?

@tarzan4771 2 жыл бұрын

What about draining the rads if you live in ground floor flat ..my pump is fine..its the manifold its attached to thats leaking from the top highest point out the plastic valve .

@Tom-fs4ue 4 жыл бұрын

Just drain boiler

@Tastebuds332 4 жыл бұрын

Just came across this-----y not close return n flow under the boiler and drain from boiler drain off instead of emptying the entire heating circuit

@markg8586 Жыл бұрын

Unfortunately changing the pump head only can potentially cause a leak in the future on these. Best off changing the whole pump unit to be honest.

@Jelly-Mack 3 жыл бұрын

Haha I'm not a plumber or gas engineer and even i know u just needed to drain this boiler. FROM on the Boiler mmmm. This boiler has a drain valve on the right hand side behind the cover. Stick a small tube or straw on and drain lol

@CurvedSlightly 4 жыл бұрын

What the fuck is the bit at the end?! You do know that in the UK you are supposed to be Gas Safe registered to mess with boilers?

@brandonmcheyenehoward1077 2 жыл бұрын

Videos like this encourage non registered individuals to work on gas boilers !!

@Tastebuds332 4 жыл бұрын

people do not follow his example----

@tonyPOPhowes 3 жыл бұрын

totally agree!!!! Not only that, his initial information is WRONG!!!!!!! The manual doe NOT say the pump is bad, it says "pump fault or low pressure". Most common problem is the pressure switch on the diverter valve.

@SunOnMyStubble 3 жыл бұрын

@@tonyPOPhowes Will re-pressurising the water system get the whole thing working again - hot water and heating, do you think? I've got a very low pressure reading on this same boiler model with no heating or hot water.

@tonyPOPhowes 3 жыл бұрын

@@SunOnMyStubble the radiator system needs pressure (needle in the green area), so if that is low it'll stop the heating coming on. Google diverter valve!!!, there is a micro switch on the back of it that is pushed by a pin coming up when heat is asked for. If it doesn't come up then sometimes wd40 can help lube the pin to rise up. Also you could depressurise system and take out 15mm nut to clean/grease. Or worse case, the diaphragm has a whole in it. No biggy to fix if you're handy. kzfaq.info/get/bejne/rrN_iZOo1M7ToIE.html not my video but handy information

@SunOnMyStubble 3 жыл бұрын

@@tonyPOPhowes Thanks for your reply. I fixed the boiler when it leaked last year (replaced the diaphragm, very simple) so, hopefully, this shouldn't be too hard.

@michaelwelsh 3 жыл бұрын

@@SunOnMyStubble how did you get on ?