I replaced my Honeywell RTH8500D wifi thermostat with a Honeywell T9 wifi thermostat. I show you how to remove old one, what tools you need, how to install faceplate and how to re-wire new one.
Пікірлер: 8
@sfootball94873 жыл бұрын
Very helpful!
@kristinet8 Жыл бұрын
What if you only have a red and black wire on old thermostat with V+ top and V+Red bottom on left and Vg top and Vg Black bottom on Right?
@kennethelkins76442 жыл бұрын
I am trying to accomplish a similar goal in my house. One thing I noticed, inside the wire cover door on the T9 it says, "Do NOT connect wire to W for heat pump". It appears you did. Did your heat work? If not, where does the white wire connect?
@letsdiy2gether2392 жыл бұрын
I do not have a heat pump. Best to check your manuals to ensure the right wire is in the right place for your system
@mrfunkington2 жыл бұрын
Where was the dual sensor set up?
@letsdiy2gether2392 жыл бұрын
I sert up the other sensor in my son's room, which is a middle-sized room. I didn't want the room to be too big or small. If too small, the sensor will register hot as the bigger rooms are still colder. If too big, the smaller rooms will get too hot. So i tried to balance by putting the second sensor in a medium-sized room
@philb2798 Жыл бұрын
@@letsdiy2gether239 how well is it working for you? I’m looking to do same, with the sensor in the master bedroom. Are you happy with how it’s working out? Thx for the video.
@letsdiy2gether239 Жыл бұрын
@@philb2798 Umm, i wouldn't say it worked great, but i do think it helped. I think you have to be selective on where your thermostats and sensors are set up to optimize how it works