Thanks for sharing

Some cameras are now including couplers where the cables can be terminated. They RJ45 connector fits though the coupler and the rubber seal is larger. Better save then sorry and not terminate the cables yet.

Power can be supplied to the camera by the ethernet cable alone as long as it is it plugged into a “Power Over Ethernet” (POE) port on a router or switch. Devices with POE ports (usually a limited number of the total available) are pricier than those without and can be a lot noisier if they have fans.

Great question! When I remember, I wrap it in electrical tape to keep any moisture and bugs out.

@@HomeTechDIY I think this is what most users are confused about. I knew I'd have to redo the terminators on my cabling but no one wanted to tell me what to do with that DC connector. Were back to junction boxes (for my install, bullet cams.. plus that connector is too big to fish through the attic in my home. Wish manufacturers would tell you this instead of making a $. Good quality though cant complain there.

I should be ok, but I like to wrap a little electrical tape on it to seal it off.

I have the same issue with some outdoor cables; they are too thick for the rubber grommet. I'm considering some neoprene stripping and wrapping mine in a few layers so it has a nice fit in the cover. amzn.to/2QiAsi9

No, there is very little space under the camera for cords.

It's an RJ45 network cable crimper. They can be purchased with a cable tester. amzn.to/3arzFqo

domenico fusco I leave the plug open if it's in a dry area. If there is a risk of moisture, I seal it with some electrical tape. I'm not sure how to answer your question on the voltage. Here is the switch I use, if it helps: www.amazon.ca/BV-Tech-100Mbps-Network-Ethernet/dp/B005GAAUMW

newfiebort Thank you. I will get the hub as this will solve my problem. What I didn't understand is why they have a 12 volt plug when POE uses 48V. It probably doesn't matter if it works with that hub.

+newfiebort wouldnt this work better to seal it from water? www.homedepot.com/p/Super-Glue-1-in-x-10-ft-Black-E-Z-Fuse-Silicone-Tape-15408-6/204237144

No, this is not required indoors.

newfiebort thanks I put it on anyway it was a piece of piss to do

Yes and no. It isn’t required for weatherproofing (unless your house is -really- damp!) but with my Hikvision cameras, the RJ45 connectors didn’t snap lock into the Hikvision sockets. The threaded cap was required to ensure the connectors didn’t slip out in case someone pulled even lightly on the cables. I’ve never had any problem with the dozens of connectors I’ve put on cables before and it was the same problem with both my DS2CD2122FWD-IS cameras so I assume it’s a Hikvision “feature,” not me screwing up.

To remove it completely you will need to cut off the RJ45 jack. Some weather seals allow the jack to slide out, but not this one.

Pretty much the same process but in reverse, except for when it comes time to remove the grommet from over the RJ45 connection. You might need something thin to side in there to push the RJ45 connection tab inwards to allow the grommet to slip over. The end cap can only be removed by cutting off the RJ45 piece.

Agreed, the plug is massive. You will either need to drill an equally massive hole in the brick or use a junction box to hide that thing. amzn.to/2trlH1p

Yea...already looking for a junction box. But that adds bulk, which I don't like. Ah well.....