I did this job on my Berlingo this afternoon, using this video as guide, and it worked a treat! Thanks for explaining so well. Top job!

Thanks a lot. Yes this was indeed a helpful video. It is exactly the ball joint in Berlingo II (B59). I cannot wait to change it!

Honestly mate the jump in your video quality is immense recently.. blown away

Best videos! My next step is changing the wishbone bushings certainly I'll do the ball joint too!

Very good video, just going to tackle this job on my Renault 5...thank you.

Very helpful. Thanks. My Citroen C3 2011 enjoyed!

Very very good mate ..welldone. youve helped me greatly so thankyou!

Thanks to you, "pig of a job" has been redefined to mean "very simple indeed"... Working my way through a C3 Picasso jigsaw puzzle and you've been so helpful along the way. Also... not related to this particular video, but I almost died laughing and will never refer to impact guns as anything but ugga guggas from now on Thanks from Scotland! 🛠️🐷

Thankyou for a good descriptive video 👍

Super useful, thanks.

Great video, thanks 👌😄

Very helpful. The advice to grind off the rivet heads was not something I had considered! Easy Peasy, now. Thankyou

Nice done...tnx for vid

Thanks, great info. If the drive shaft does pull out of the gearbox, does it just slide back in when the new joint is bolted back in place?

Good vid to the end ,my 306 balljoint lock bolt got damaged by previous balljoint,can i find another one of any size?

you make this look soo easy, wached it many times to learn but fk i hate doing lower ball joints on my 208. done it many of times as the morons at euro car parts give me the wront ones the 63.5mm lenth ones over the 75mm lenth ones. NGL ive run the shorter ones for 300 miles and the only issue is when on full lock there is a clunck, i presume its the ball joint clicking up in the hub or the car is totaly fked 😂😂. btw only done it as a last dich effort as i need the vehicle for work e.g the car is my job. also amazing video

Hiiii great video, torque bolt? Thanks

Good vid Piggy, i did pull out my driveshaft though resulting in a gooey mess! p.s do you know how to get a DS3 wishbone bolt in as the dam driveshaft is in the way hence my gooey mess trying!!

Hi sir , i owned 206 , usually when am push the brake and turn the steering wheel right or left (when i park the car for example or leaving the park) sound like a something broken been heard , kindly i need the info to solve the issue , so do you think that sound because of the failer ball joint ?

Hi. I’m sure this helped a lot out there. Cheers!

Perfect! Got my 106 to do 😭

Why not put some greas on the pin before you wigel it in? I do and it goes so much easyer.

Could this be the problem when I turn sharp left, it literally sounds like a woodpecker pecking

Lucky u i cant even get a good used one 😢😢😢