Рет қаралды 3,173
On this episode of the Miata build we'll be finishing up the Miat Build we’ll be wrapping up the cooling system. We’ll be installing a coolant re-route, lower radiator hose, and clamps. This is a must have mod for any Miata to protect your engine.
The engines that came in the Miata were originally designed for Front Wheel Drive application where the engine sat horizontal. The coolant was meant to go through the back side of the engine to the front.
For the Miata the engine was mounted longitudinally. Mazda decided to have the coolant go into the engine from the front and back out the front
Mazda then replaced the water neck inlet with a heater hose outlet.
This causes cylinder 3 & 4 to receive less cooling than the front cylinders and sometime causes issues due to lack of cooling.
A coolant re-route essentially returns the coolant flow back to what the engine was originally designed for.
I hope this helps you out if you are doing the same mod!
The install only required basic tools and some time. I hope this video gives you the confidence to do it yourself too!
► Buy me a coffee if I helped you with this video! buymeacoffee.com/wilsbuilds1
Links
Coolant Re Route Spacer - Cobalt - mossmiata.com/910-852-thermos...
Kia Sephia Water Neck Part# = 0K24715172A - amzn.to/42ucaEy
Gates 22436 Premium Molded Coolant Hose - amzn.to/3oRXkKj
Water Neck Block Off Plate - miata-source.com/products/coo...
Miata 94-97 Thermostat - BP6F-15-171A - Coolant Thermostat - amzn.to/3MS6UVF
Coolant Temp Sensor - 179700-0220 89422 - amzn.to/43u6DiD
Constant Tension Hose Clamps - amzn.to/3MM7AvA
Hose Cutter - Gates - amzn.to/43p9XM0
TEKTON Torque Wrench - amzn.to/3YimLRO
Manfrotto Tripod - amzn.to/3VmiZp0
0:00 Intro/ Parts Overview
0:51 Rear Water Neck Removal
2:20 Reroute Housing Assembly
5:52 Reroute Housing Install
7:53 Radiator Install
9:58 Cutting Upper Hose
10:52 Outro