Porsche Camshaft deviation
Рет қаралды 5,852
2 жыл бұрынMy friend Grant dives into the M96 motor to change those chain rail pads!
@DanWFromMystic Жыл бұрын
Love it! Especially the Special Tools.
@robjustme1173 2 жыл бұрын
I have been needing this. Thank you!
@Getsomepiggy Жыл бұрын
Good pacing and easy to follow. Thanks!
@richardowens6520 2 жыл бұрын
Thanks
@ceelos4979 2 жыл бұрын
Great video guys! I have a 2006 cayman 987 and I have a P0018 code I can’t figure out. I replaced all cam sensors and nothing :(
@Ksenaify 2 жыл бұрын
Hi! I just want to change my dead engine M96.20/65X to same M96.20/65w. The big proplem in this operation its camshaft sensor. I have two sensor in both camshafts, but in new same engine only one camshaft sensor in passenger side (Left hand drive). What you can recomend? Will it be the new engine without second camshaft sensor working well or not? Do you know decision exists?
@NewArt1 2 жыл бұрын
I don't think that you would have any problems. You should ask a real technician in an independent Porsche shop. I am not an expert.
@vicky-nc3to Жыл бұрын
Hello sir, my 2002 996 turbo cam position 1 deviation is -7.75 °kw & cam position 2 deviation is -4.94° ... Should I be worried, can you explain ? These are values at idle Thankyou
@NewArt1 Жыл бұрын
Hi Vicky, I must admit that I know little about the turbo engine. It is not an m96 engine but rather what we call a Mezger engine. That said, if the chain internals are similar, I would expect to see worn guide rails. Anything more than 6 degrees would signal time for a change. I suggest that you talk to a trusted Porsche indie.
@granthargrave2319 Жыл бұрын
Before reassembly have a look at this video kzfaq.info/get/bejne/mJ92YNp2sd67Y6M.html which has an important tip.
Nathans Porsche Workshop
Рет қаралды 31 М.
Nathans Porsche Workshop
Рет қаралды 19 М.
Porsche Club of America
Рет қаралды 44 М.
Wheeler Dealers
Рет қаралды 959 М.
КИНОТАЧ
Рет қаралды 902 М.
Crafts people
Рет қаралды 6 МЛН
Erdes Cars
Рет қаралды 9 МЛН
Kingofnigte
Рет қаралды 6 МЛН