This is by far the best video on PB assembly.

Best instructions ever!

Thank you for the video. You did a good job demonstrating and explaining. Enjoy your time on the water!

I just purchased a 10ft 2021 with Bimini top + other accessories, that Bimini top looks like a Dreadful nightmare although once the Bimini is assembled mounting/dismounting don't seem to be too much of a task, so thank you for this how to video which is very detailed by the way & much needed & appreciated.

Your calm voice makes installation process even easier, thanks!

A very unique Boat! I enjoyed watching how this was assembled and presentation which made listening and learning about a how to video easily understandable experience. 👍👍👍❣️

Love to see more videos of the Porta-Bote and your soothing voice describing it!

Great video, great instructions on how you assembled your boat. Please post some videos on how you find the boat on the water. It would be good to see how the boat does in the water and running with a motor attached, etc. Nice work guys.

Thanks for the video. I'm looking a 12ft model, and your video answered alot of questions I had pertaining to use and function.

Love the video. You are so calm and describe the process so well - especially for an excitable guy like me! Lol. I'll pass on the Bimini- even your calm demeanor couldn't suppress the angst I felt watching that process. Hope to have my PB delivered by the end of July. Thanks again.

Very detailed...thank you! Now to open our boxes and begin!

Great Video ! 👍🏻

Great Set-Up video- best on the Web that I've seen! It's all straightforward and simple, excepting the Bimini part which is nearly a quarter of the video- that tells you things about the issues of that item 😉

Well explained.

A few additional tricks When first opening the bote, kneel with 1 knee on the lower edge of the bote, push upper side away. Use spreader bar to open rest of way. Start spreader bar near the stern so the stern flexes open the maximum distance. This makes hole alignment in transom easier. The hole alignment is the most trying part. Be sure the spreader bar square cut out is positioned so it can catch the near (bottom) edge when the bote is half open; this gives you a chance to rest. I lost some of the hardware; I replaced with clevis pins or long nuts and bolts. Try to get bolts with a round loop as the head, much easier to tighten by hand. Seats go in easier if the middle bracket is canted off to the side; use the spreader bar to push it in place after slotted side holes are bolted. Install the cart wheels near the rear at first as the sides are near vertical; then slide them forward as needed for balance. The further forward you move the wheels, the lighter the front end is to pick up

I used a 6 hp for my 12 foot and then down to 2.5hp suzuki. perfect!

Well explained. Does the 10 ft version offer enough space for 4 adults or did you ever used it with 4 adults?

Great vid, can you please tell me the measurements of the assembly stick and the notches? Mine broke and I need to build a new one.

I as well ordered the Bimini top, is it useful ? Is the Bimini top flimsy/finicky or does it function as intended ? Thank you in advance.

does it float?

I can when buy portaboat ?? Thanks for yuo answer.

Dónde puedo comprar uno de esos. Soy de Argentina

How much did it cost?

What size of boat is that?

Hope that Shark isn't smart enough to figure out your boat is made of a piece of Vinyl??