Рет қаралды 43,631
Welcome back guys! We are at the final step before getting the final dyno number for my 2014 Silverado.
In this video we are showing how to install the Performance Driveline Single Piece Driveshaft on my 2014 Silverado.
This installation should work for the following vehicles but always double check for your specific model.
2014-2018 Silverado
2014-2018 Sierra
It also may be similar on the following vehicles:
2015-2020 Tahoe
2015-2020 Yukon
2015-2020 Suburban
Note: The performance driveline driveshaft is currently not speed rated - only HP rated but it should be able to handle the higher speeds.
👉🏼 LINKS TO PURCHASE TOOLS & PARTS FEATURED BELOW👈🏼
#PerformanceDriveline #SilveradoDIY #SilveradoDriveShaft
⚠️Try anything shown in this video at your own risk ⚠️
********************************************************************
Associated Videos - AFM DOD Delete Series
********************************************************************
Full DOD delete series below:
Part 1 - Baseline Dyno: • AFM Delete Part 1 - Wh...
Part 2 - What Parts Do You Need • AFM DOD Delete Part 2 ...
Part 3 - Engine Removal: • AFM DOD Delete Part 3 ...
Part 4 - Engine TearDown: • AFM DOD Delete Part 4 ...
Part 5 - Installing New Parts: • AFM DOD Delete Part 5 ...
5A - Cam Phaser Install: • AFM DOD Delete - How t...
5B - Trunnion Upgrade: • How To Upgrade GM Trun...
5C - Lashing HP Fuel Pump: • How To Properly Lash H...
5D - Injector Seals • High Pressure Fuel Inj...
Part 6 - Reinstalling Engine: • AFM DOD Delete Part 6 ...
Part 7 - Tuning and Dyno Run:
Part 8 - Installing Intake Manifold, TB, Air Intake, & Driveshaft:
8A: AIRAID Intake: • Silverado 6.2 AIRAID I...
8B: 6.2 Intake Manifold and TB: • 6.2 Intake Manifold an...
8C: Drive Shaft: • 2014-2018 Silverado Dr...
Part 9 - Tuning and Final Dyno Run:
************************
🔩Parts (Affiliate Links)
************************
For the parts needed to delete AFM check out: • AFM DOD Delete Part 2 ...
GM DriveShaft Bolt (x4 needed) #11548472: geni.us/GM_DriveShaftBolt
GM Yoke Retainer Clips (x2 needed) #23107857: geni.us/GM_YokeRetainerClip
Make Sure to tell Performance Driveline that you heard about them from us!
Single Piece DriveShaft (Note, I went with the high HP version):
geni.us/PD_SinglePieceDriveS
Note: These 2 piece drive shafts are only for 2WD trucks - you must call for a 4x4 version
Two Piece DriveShaft Under 500HP: geni.us/PD_TwoPieceDS_Low
Two Piece DriveShafter Over 500HP: geni.us/PD_2Piece_DS_High
**********************
Tools (Affiliate Links)
**********************
Note: The Max Torque Spec on this 1/4" is 200 in/lbs while the torque spec of the bolts is 216 in/lbs (18ft lbs) but I'm unsure if a larger torque wrench will fit with the socket.
1/4" Torque Wrench: geni.us/GW_14_TorqueWrench
Here is the 3/8" torque wrench, I will try it at some point and report back.
geni.us/GW_38_TorqueWrench
Wobble Sockets: geni.us/WobbleExt
***********************************
⚙️Torque Specs
***********************************
Torque Spec #1: 18 ft-lbs
******************************************
🎬 Recording equipment (Affiliate Links)
******************************************
📷 Video
Canon EOS 80D Digital SLR: geni.us/Canon-EOS80D
----------
Thank you to all of our fans and subscribers for supporting us on our journey!
FOLLOW US ON INSTAGRAM: @THESUNDAEDRIVE
CHECK OUT OUR WEBSITE & BLOG: www.thesundaedrive.com