triumph street triple quarantine service

Рет қаралды 12,221

FRB Freeridebeans

4 жыл бұрын

while we are on lock down thought I would pass the time and service my bike.
Enjoy 😊

Пікірлер: 56

@jamiemadison8082 Ай бұрын

Really appreciate this video. Thanks for the effort

@frbfreeridebeans Ай бұрын

No worries thanks for the view and comment it’s very much appreciated 👍

@EtaParseids 4 ай бұрын

Thanks for the video! Welldone! Just as a note from a fellow Street Triple owner: When draining the oil, have the bike on the side stand as per the manual. This makes the drain plug the lowest point on the bike. Allows the oil to drain faster, and helps drain more oil overall.

@frbfreeridebeans 4 ай бұрын

Thanks for the view and comment it’s much appreciated. I will try that in a couple of days when I do the oil change. I’m also going to be doing a video in the next few days on fitting some clipons to my striple 👍

@Dittoo89 2 жыл бұрын

Thanks for the video, always useful to see someone taking the time to film themselves doing a detailed service! Just an FYI for the fuel tank, before removing the fuel hose, but once the electrical connectors are disconnected, you can crank the bike to remove the pressure in the fuel pump. It will only run for a couple of seconds and cut out but then when you remove the hose it doesn't spray fuel anywhere.

@frbfreeridebeans 2 жыл бұрын

Thanks for the info I’ll definitely try that next time 👍

@MikeStar2000 3 жыл бұрын

A good and informative video, thanks for that! Will be doing the very same service for my Triple in a month or so. 🙂

@frbfreeridebeans 3 жыл бұрын

Thanks for the view, comment and sub it’s very much appreciated. Welcome aboard 👍

@manrajgill5270 3 жыл бұрын

This is a very informative video. Thank you for showing everything.

@frbfreeridebeans 3 жыл бұрын

Thanks for the view and comment it’s much appreciated 👍

@mateo411_ 2 жыл бұрын

Nice video!! Really useful even for a 2021 model, thank you :)

@frbfreeridebeans 2 жыл бұрын

Thanks for the view and comment it’s much appreciated. Glad it’s helped 👍

@LazioKa 3 жыл бұрын

thanks for this

@frbfreeridebeans 3 жыл бұрын

No worries glad it helped 👍

@brentgunder967 Жыл бұрын

You should also start the bike with the cap off of the radiator in order to purge any air from your cooling system

@frbfreeridebeans Жыл бұрын

Thanks 👍

@LLS.R 3 жыл бұрын

I’d replaced the triumph oil filter with one from k&n. You can tighten/loosen these with a 17mm socket.

@LLS.R 3 жыл бұрын

I used tuneecu to balance the throttle bodies. Might use the extension hose and cable (which is written in the service manual) next time so in have more room to adjust.

@eskertoo 3 жыл бұрын

Those K &N filters can kill you.They fail at the nut weld and leak oil which gets all over the rear tyre.It happened to me last year ...I suffered a huge slide and almost high sided.They are now made in China and are poor quality.Sometimes they literally explode.Please check it out ,don't take my word for it.You are playing Russian Roulette.I bought mine from a reputable online seller and I have 2 Triumph bikes that have had these filters fitted every year with no problems but now I won't ever use them again.The seller did not seem interested after I told him I fitted it myself.I reckon he thought I had over-tightened it but I only ever put them on by hand....the nut is for taking off only.

@frbfreeridebeans 3 жыл бұрын

Wow what a horrible experience glad you’re ok though buddy

@jbean530 Жыл бұрын

Thanks for sharing. That’s terrible because KN are expensive and usually top shelf. I have k and n air filters in my motorcycle and considered these for oil. Thank God you’re ok.

@scottwinning7484 2 жыл бұрын

Great video mate, gonna have a go on my 2017 RS, it's due its 3yr service but it's only done 1800miles, what's your opinion? Is a similar service to yours enough? Seen many people saying doing valve check etc is a waste of money at such low miles even though its at 3 years.... don't worry I won't blame you if it goes pear shapes.

@frbfreeridebeans 2 жыл бұрын

Valve checks should be done at 12k miles buddy so you should be fine. But I’d ask a dealer or check your service book. Sorry I couldn’t be any more help 👍

@LunchBXcrue 3 жыл бұрын

Did you not prime the oil pump before installation?? I've heard you should do that because the oil level will drop quite a to fill it plus all the oil channels. Lucky you the coolant res is down there, on my 2020 striple r its above and forward of the rearset which makes it a bitch to get at.

@frbfreeridebeans 3 жыл бұрын

Hi thanks for the view and comment. Do you mean the oil filter? If so then the answer is no I only put some oil around the oring. And before I start the bike I do flick it over a few times to prime it.

@timk1980 2 жыл бұрын

Great video bud, very helpful. I want to have a crack at this… where did you get the crush washers for the coolant? (Assume you got the sump one with the o/filter) 🏍💨 👌

@frbfreeridebeans 2 жыл бұрын

Thanks for the view and comment it’s much appreciated. I got the crush washer from eBay but you can order them World of Triumph or fowlers or even Amazon. Hope that helps 👍

@timk1980 2 жыл бұрын

Thanks bud, I’ve got all the service items now, just trying to find the correct sized crush washers and the correct coolant, don’t suppose you’ve got part numbers or sizes? 🍻

@frbfreeridebeans 2 жыл бұрын

I’m sure this is the correct washer T3551111 | Copper Washer M6 x 12

@frbfreeridebeans 2 жыл бұрын

www.worldoftriumph.com/collections/100061247-4-2?type=street-triple-r-from-vin-560477-to-vin-806645

@Avensur 10 ай бұрын

To remove the oid oil filter with a channel lock is ok but no to tight the new one. It will put a dent on it.

@AbjectMaelstrom 2 ай бұрын

Hand-tight on the filter. No need to hulk it.

@frbfreeridebeans 2 ай бұрын

@AbjectMaelstrom 🤣🤣 didn’t hulk it 🤣🤣it was only hand tight as I’d got oily hands so just nipped it up

@AbjectMaelstrom 2 ай бұрын

@@frbfreeridebeans 😁👍, gotcha. Just be careful. Definitely had some folks hulk it down then I have to wrench it to take it off.

@AbjectMaelstrom 2 ай бұрын

@@frbfreeridebeans how many Km you got on it now?

@frbfreeridebeans 2 ай бұрын

Nearly 11k but I’ve not been riding due to ill health. But keep an eye on the channel as I’m in the middle of ordering the parts to change it into a Daytona minus the engine 👍

@chrisdu-val5712 3 жыл бұрын

Hi mate great video. I have just brought a 2014 street triple r with 10000 on clock. When would u recommend major service some have said 12 but can stretch it to 13 or 14 thousand. Also what's it roughly cost for a major service thanks

@frbfreeridebeans 3 жыл бұрын

Hi thanks for the view and comment it’s much appreciated. As for the service it’s 12,000 miles it involves a valve check I’ve heard of people paying £800 ish for main dealer to as low as £450 at an independent. Personally I wouldn’t push my luck over the mileage. IMHO it’s not worth the risk but that’s a choice you’ll have to make. Sorry I can’t be any more helpful but I hope that helps.

@deanf8206 2 жыл бұрын

Great video ... oil filter too tight though.

@frbfreeridebeans 2 жыл бұрын

Thanks for the view and comment it’s much appreciated 👍

@juanj4449 2 жыл бұрын

Mantenimiento difícil, muchos tornillos y mucho montaje

@frbfreeridebeans 2 жыл бұрын

No not really if you take your time it’s quiet easy. Thanks for your comment and view it’s much appreciated 👍

@jbean530 Жыл бұрын

Wow. Removing the tank just to get to the air filter. They really don’t want you to do your own filters.

@frbfreeridebeans Жыл бұрын

It is what it is 🤣

@user-gg1pv4of2s 3 ай бұрын

Hello, should we mix antifreeze with water or should we put it pure?

@frbfreeridebeans 3 ай бұрын

Thanks for the view and comment the coolant I used you use as is no water

@user-gg1pv4of2s 3 ай бұрын

@@frbfreeridebeans Please, should I use the antiphthisis pure or mix it with water?

@1airways Жыл бұрын

Oh please not the pipe grips torquing an oil filter

@frbfreeridebeans Жыл бұрын

It was tight as I’d got oil all over my hands 🤣🤣

@Maverick-moto 10 ай бұрын

There are such things as oil filter removal tools…. You also don’t even wipe the face of the oil filter housing before you screw the new filter on. Amateurish in the extreme. Sorry but I won’t be watching any more of your ‘instructional’ videos….

@jamiemadison8082 Ай бұрын

@@Maverick-motoLet's see your video then mate? Oh that's right you don't have one. Shut it you melt.

@followmetothemorgue 2 жыл бұрын

What spark plugs do you use?

@frbfreeridebeans 2 жыл бұрын

Hi thanks for the view and comment it’s much appreciated. The spark plugs are NGK CR9EK hope that helps 👍

@followmetothemorgue 2 жыл бұрын

@@frbfreeridebeans Very much, i appreciate it very much!

@cantsolvesudokus 3 жыл бұрын

The oil filter is such a bad design. If you were to do an oil change while the exhaust is still hot you might have yourself a nice little fire...

@frbfreeridebeans 3 жыл бұрын

Yeah you’re right about the placement. Even though I cleaned most of oil off there was still quite a bit of smoke when I ran the bike afterwards. Thanks for the view and comment it’s much appreciated 👍