Not the best camera man , but good enough to help me repair my hp110. Really appreciate it 🙏
@thomasmeyer8798
Thx for this video - today, I did not change just the belt but also the M3 screw, which secures the left tip of the encoder strip. I trusted that there was a corresponding thread behind a 13 mm width across flats. Unfortunately, the assumption was wrong - Knaaack!
@highoffice20192 жыл бұрын
Perfecto, Casfer, pude cambiarlo solo con tu excelentes videos
@hightechsigns82482 жыл бұрын
Great Video, I replaced my HP 360 belt myself with a new belt and pulley from eBay for just $165 - Thank you
@basslover1345 Жыл бұрын
Please do another video next time you replace a belt using a different camera person. Who ever recorded this video probably had so attention disorder or clueless
@leticiadiferdinando67593 жыл бұрын
me sirvió mucho. Gracias por compartir
@nywrapz3387 Жыл бұрын
great video thank you had to replace my belt came out good
@galvezprinting2 жыл бұрын
Thank you, it help me a lot, was able to fixed it with your instructions.
@prodecals3 жыл бұрын
exelente! muy bueno, se entiende perfectamente1
@hercom253 жыл бұрын
Great , Thank you for sharing this!
@appaworld41583 жыл бұрын
정말 감사합니다 많은 도움이 되었습니다.
@eloysoto1687
You the GOAT fr 🐐❤🔥❤🔥
@JimHenchen21 күн бұрын
Thanks for showing the order of the parts needed to be adjusted, cleared or removed before the belt repair is made. During the video the print heads were removed. After the encoder strip was put back, that was the end of the video. Is there a specific procedure in putting the print heads back into the carriage?
@guerrillasneeded Жыл бұрын
Thanks. The HP 365 service manual under 'Belt Assembly' also has this process step by step.
@zetexx2
nice video!
@MarceloRizzimscomvisual Жыл бұрын
can you tell me what type of fabric is used in the L330 printhead maintenance cartridge?
@jimbow3274 Жыл бұрын
What he don't show or tell you is that it takes two people to put the encoder strip back on and the spring tensioner only goes on one way. there is a slight offset with the screw hole. So when you have the carriage upside down putting the belt on, the tensioner spring must be facing down so when you flip it over you'll be able to see the spring open side. Still thanks for posting this video, It did help!
@chaiyapornsribuabal978
Hello guy, pls you help me something. Is there parameter to be set after finish replacement? Or it can be used immediately? Thank you very much.