how to or not to straighten a trailer ramp

No video

how to or not to straighten a trailer ramp

Рет қаралды 1,146

daveknowshow

Күн бұрын

Пікірлер: 20

@careyward3405 Жыл бұрын

Another great video and informative!! Always look forward for your videos

@daveknowshow Жыл бұрын

thanks Carey, I need and appreciate the support.

@LouisianaTractorworks Жыл бұрын

Nice to see more videos from you Dave. That was a heck of a ramp. Well built. You did a good job getting that C- channel straight. That's some tough stuff. Have a good week! See ya!

@daveknowshow Жыл бұрын

thanks brother

@GrampiesWorkshop Жыл бұрын

Hello there Dave!! That was bent up pretty good, but with the heat and hydraulic jacks, it's usable again. Nice job. Take care!!!

@daveknowshow Жыл бұрын

thanks my brother. went faster and better than I expected.

@1rustytree Жыл бұрын

Good info Dave! I'll have to try that chain and jack method!

@daveknowshow Жыл бұрын

i sure has saved me a few times

@GardenTractorBoy Жыл бұрын

I was surprised how much steel was in that ramp, I am guessing it would not have been easy to bend it in the first place. Great job getting it back to where you need it

@daveknowshow Жыл бұрын

for sure these ramps are made for some serious weight. I'm thinking small skid steer maybe. all that heat and 20 tons just did get it where it can be used. hope your thanksgiving went well.

@ItsaboutMakingnotBuying Жыл бұрын

Another job well done Dave. Stay safe and warm. Later

@daveknowshow Жыл бұрын

thank you my friend

@chuckb.5076 Жыл бұрын

Hey Dave. It's coming along great! Hope all is well. Thanks.

@daveknowshow Жыл бұрын

its coming along, trailer is doing better than my life is. lol ha ha

@bayareasparky9180 Жыл бұрын

Dave, if you're not careful you'll turn that into a "dump trailer" if you know what I mean. 😊 Hoping you had a good Thanksgiving Brother.

@daveknowshow Жыл бұрын

lol if I can get it close to a dump trailer, I'll be happy. lol hope your thanksgiving went well also

@devaningles7018 Жыл бұрын

Hey Dave, I watched your video from a couple of years ago about you installing a diverter valve on your l2800. I recently purchased a l3200 and i have the same issue with a jerky 3 point hitch. Have you experience any issues since the diverter has been installed? Thanks.

@daveknowshow Жыл бұрын

NO ISSUES SO FAR! seems to be a decent work around

@KS-jk5xw Жыл бұрын

I would had used the log splitter if you could control the pressure

@daveknowshow Жыл бұрын

I thought about that but balancing the ramp on it was something I wont sure about. I have used the log splitter for many other things though in the past. I like how you think!!!