REMOVING UPPER INTAKE MANIFOLD ON AN AUDI 3.2 V6

Рет қаралды 6,414

Жыл бұрын

REMOVING UPPER INTAKE MANIFOLD ON AN AUDI 3.2 V6
If you would like to help support this channel please take a look at these tools I recommend and use daily.
Streamlight usb rechargeable pen light (affiliate link) amzn.to/3GxgWtl
Automatic noise cancelling ear protection (affiliate link) amzn.to/3Q7ZiPZ
Reasonably priced metric wrench set. (affiliate link) amzn.to/3GvIkHV
Excellent 1/2in drive split beam torque wrench (same as snap on) (affiliate link) amzn.to/3Z5qu67
Thank you and thanks for watching

Пікірлер: 6

@aster5031 4 ай бұрын

10/10

@EuropeanAutoRepair 4 ай бұрын

Thanks!

@vinividivici3 Жыл бұрын

Thank you for this informative video. I will need to remove mine to repair a lot leaks and do some carbon cleaning so this helps a lot. One of my faults is a P2070 fault which is a stuck open air intake valve. I was trying to look for a vacuum lever actuator which wears out that pulls the intake valves by the intake runners but I dont see them. I have seen videos of this on the B7 3.2L but my engine (B8) does not. Does the B8 use a different mechanism? Thank you

@EuropeanAutoRepair Жыл бұрын

Does your car have the supercharged 3.0tfsi?

@vinividivici3 Жыл бұрын

@@EuropeanAutoRepair No, it is the 3.2L FSI V6 (CALA), same as in this video.

@EuropeanAutoRepair Жыл бұрын

On bank 1 is off the front on passenger side, they are mounted on lower intake manifold, I’ve seen some of those that actually don’t have those flaps but I’m unsure which that is