used a torque wrench to loosen the lugs??!!! nice....

SO long ago, but once I replaced my turbo wastegate flap and adjusted my BOV, that ticking lessened. Additionally, I ran some octane booster thru it for a couple tanks, and it hasn't come back since. Techron may have also done the trick. Not a huge fan of additives, but it SEEMED to have worked for me :)

Does this fit the x156

Perfect time to install our methanol coupler!

hello do you have a link? who did your reprogramming of this turbo please?

OOOk, after time with these 600Hp I ask, The automatic gearbox is it exploded, broken, faulty or.... keeep working good ?

excuse me,what is that sound generator for? thanks

Only video of this on the net and its not a very good or complete video. You remove things off camera and have hoses previously removed.

I love it great job 👏👏

Any updates on how its running now?

Can this Intercooler fit a GLA 250 turbo 4Matic x156 engine

I need help!! I just got a GLA 250 and wanna kno what aftermarket parts I can install on my car.. I'm thinking since the CLA has the same motor I can use those parts but not sure.. or can I use the same parts as the GLA 45??

nissan sentra R

nissan sentra R

Is it possible to swap the compressor wheel without removing the turbo but just the front housing from the backside ?

Does the cla need any upgraded coolers or heat exchangers etc or can it handle big turbo with custom tune

I have the same Turbosmart dual port bov on my stage 2 mapped A45, sometimes when on the throttle it makes a spitting noise going through the revs which I assume the spoiling will suffer, don't know why this is.

Omg you didn't even start it haha

Bonjour j ai installé la même mais je n entends plus le bruit de décharge , pouvez vous me dire pourquoi ?? Merci !!!

hi, i bought it too. can you give me some info if you can in private for the installation?

Toyota headed

How did you raise the plastic The bit with the wires in to get the lower bolt. I seem to have no space to put a spanner beneath the Plastic to undo the lower bolt

dude I have been looking for good info like this for three years do you have anymore videos you can share to show your tuning and the intercooler upgrade results ? I would love to know if y

What fuel pressure at the rail are you seeing currently? What were you seeing before to cause the noise? Was the AMS pump causing too much pressure? I think I'm experiencing the same problem with my car, except the car doesn't run well at all. Sent AMS logs and they said "its fine".... baffled.

So that's it haha over just like that no drive bys no dyno runs just a little rev and done haha bloody he'll

Wee ever going to hear or see this car run ..

So that only occurs on modified A45 AMG? Stock ones should do that? Or is that possible that bad quality petrol/gasoline can lead to a similar pump noise?

That down pipe 😍

Hi M.J.R., is there any update about the TB V2 is handling high boost presure ? I've just blown my hybrid turbo into pieces and the non-electronic TB plump back valve was fitted. My friend who studied engine technician, suspected that the BOV zylinder stuck and didn't opened properly. That caused my turbo shaft to litterlaly explode. The compressor wheel had been found in the intercooler and air filter and the exhaust wheels is stuck in the downpipe.... Turbo and IC has already been ordered, but I'm not sure if I should install the TB V2 BOV or go with the OEM one ?

After just about running it for about 1 year, the AMS fuel line began to leak at the back of the nut, which connects to the HPFP. Car had to be shout down. Somebody experienced the same issue ? Due to my hard coilover and stabiisator setup, the harder metal of the fuel line, weared out the inner part of the HPFP connector. Now I'm screwed...

about the sound generator? do you need that? do you have problems without that?

Updates?

does this BOV work for the cla 250 2018 model ?

Thanks for the video, Is the follow up video coming?

What year is your vehicle I have a 2018 CLA 45 & I don’t know which one to get the Mercedes-Benz A45, CLA45 And GLA45 AMG Kompact Shortie Dual Port - VR03 or Kompact EM BOV VR2 Dual Port please reply ASAP my car is in the shop and will be out next week & need to know which correct part to order.

Where the sound???? Wtf

how is your transmission holding up? I’m planning on getting a 17 a45 but heard something bad about the transmission not cooperating with big power bump

great video, I admire what you have done with your GLA. Recently I went on my 215 GLA45 with stage 2 at AMS Performance here in West Chicago, I never knew that 2014-2016 models didn't have recirculation valve, at it's place there is just aluminum plate. I got brand new turbo (old one had faulty waste gate actuator) now I'm worried about this one, looks like BOV VR2 Dual Port is a must. As I mentioned, it's an older version of the turbocharger, not sure if there is OEM harness were I can plug in control signal electronic actuator wire. Do you know if it's possible to fit this bov on an older model of GLA ?

S da a a

Did you ever get the metal noise to stop also are you going to make the blow of valve sound videos. I only ask because I have a 2017 gla 45 and just bought everything they had form AMS for the GLA. just want to make sure the metal noise stopped with the new BLV. before i start my installs.

nice to meet you. I am interested in your tuned vehicles. Can I know the messenger or email address where I can chat with you??

nice to meet you. I am interested in your tuned vehicles. Can I know the messenger or email address where I can chat with you??

Nice job! Any documented footage of the performance improvements? Also what can the gearbox handle torque wise, do you know?

Hi. Can i get an email or nimber to contact. I am facing a problem with an A45. Using hp tuners. Thanks

Hey there, nice install. Going on a year now, hows the car running?

niCE job for the upgrade. Thanks for sharing the video.

Great explanations

Hey just curious I have CLA 45 M133 engine 2014, did a pure turbo swipe. My new and old turbo came with the BOV plate should I install BOV ?

Nice job. THX!

Did you sell the intercooler and go with something else?